Cannondale Scalpel SE 2018-2020 Owner's Manual

Show PDF Add to My manuals
1 Pages

advertisement

Page 1 of 1
134924 Rev 1 - Updated: 01/16/18

Tech Note
(EN)
2018 Scalpel SE 2

Down Tube Clearance ,
Fox Performance 34 Fork
Required Lower Headset Cup & Crown Race

2018 Scalpel SE 2 sizes S, L and XL with the Fox Performance
34 fork require lower headset cup
KP213/BLK and
crown race
K35108. These parts are not required on M size
frames.

KP213/BLK is a 12mm height cup which provides the additional
and necessary down tube clearance between the Fox

Performance 34 fork adjusters and the down tube.

Additional clearance is needed on S, L and XL frame sizes to

prevent the fork adjusters from striking the frame when the

handlebars are turned.

If 2018 Scalpel SE 2 sizes, S, L, and XL does not have the
KP213/BLK
lower cup and K35108 crown race installed already,
the parts must be installed by a Cannondale Dealer according

to the service instructions.

At this time, KP213/BLK and K35108 are only indicated for use
with 2018 Scalpel SE 2 sizes S, L, and XL and the

Fox Performance 34 fork. These parts should not be used on

other 2018 models.

Installation

To install these parts, the SI bearing should be removed from
the lower head tube. It is to be re-used.

The lower bearing must be pressed into the
KP213/BLK cup
first. Be sure to apply light grease to the bearing and the

cup when using
(Park Tool: HHP-2). Use the correct headset
adapters when pressing the cup/bearing combination into the

head tube.

The existing 4mm crown race must be removed from the fork

using
(Park Tool:CRP-2) and crown race K35108 installed using
(Park Tool: CRS-15.2)
in its place.
If it is necessary to change the lower bearing later, the
KP213/BLK cup and bearing combination must be driven out

of the head tube together. Use a wooden dowel and mallet.

Locate the dowel inside the head tube on the upper edge

of the cup and drive out around the cup evenly.
The bearing
can then be extracted from the cup and replaced and the

combination re-installed.

WARNING

Information intended for use only by Authorized Cannondale Dealers.

Special tools and skills are needed.
Bike Owners must not perform the
work described. Serious injury or damage can result.

KP213/BLK
12mm
K35108

ATTENTION BIKE OWNERS
- Cannondale Tech Notes are informational
only. Tech Notes can be downloaded from our website. Please have any

described work performed by a Cannondale Dealer.

NOTICE: Damage resulting from improper service, incorrect parts, or

modification, IS NOT covered under the Cannondale Limited Warranty.

Clearance area

LOWER BEARING

(SI to 1.5)

CROWN RACE

LOWER CUP

INCORRECT
CORRECT
4mm

CROWN

RACE

NO

LOWER

CUP
  • Page 1
/

advertisement

Related manuals

advertisement