Smartmi CJXJSQ02ZM Humidifiers User Manual

Show PDF Add to My manuals
1 Pages

advertisement

Product Introduction
Safety Instructions
READ AND SAVE THESE INSTRUCTIONS
Specifications
Regulatory compliance information
Product Introduction Usage
Usage Usage
Repair and Installation
Control Panel Instructions Adding Water
Turning the Machine On and Off, and Changing Modes
Air Dry mode
Adjusting Brightness Reseing the Wi-Fi
Cleaning the Water Tank
If Air Dry mode is on:
Add water through the refilling port Add water into the water tank
Water Level Indicator Mode Indicator
Light Status Light StatusWater Level Current Mode
4 5
Control Panel
Exhaust / Water Refilling Port
Upper Casing
Evaporating Basin
Evaporating
Basin Knob
Water Tank
Water Level Limit
Lower Casing
Temperature and
Humidity Sensor
Water Level Indicator Mode Indicator
Suitable Water: Tap Water, Mineral Water, Purified Water
Note: If you fill past the maximum water level, the water level
indicator lights will flash and the machine will give off warning
beeps, and water should be stopped adding immediately.
Note: If you frequently use the humidifier,
we recommend cleaning it once a week.
You can rinse the water tank with clean water, or
wipe it down with a soft cloth to ensure the
cleanliness of your humidifier, and prevent strange
odors produced by stagnant or dirty water.
You can directly add water through the refilling port
while the purifier is powered on. The water will flow
down into the tank, and the water level indicator will
change to reflect how much water has been added.
Stop when all the lights are on.
Take off the top half of the purifier, and directly add
water into the tank. Take care not to fill past the
maximum water level indicator.
Press the Power / Mode Buon to turn the machine on.
The first time you start the machine, it will default to
automatic mode. You can press the buon again to
switch modes. Holding the buon for 2 seconds will
turn the machine off.
Press the Wi-Fi / Light Buon to adjust brightness
between high, low, and off.
Quick Set-up
This product is compatible with the Mijia Smart
Platform. It can be controlled through the Mijia app,
supports the MIUI system, and can connect with other
Mijia smart products.
Search for “Mijia” through your
app store, or scan the QR code
below to install the Mijia app.
Enable your phone’s Bluetooth,
and go to the front page of the
Mijia app. Press the + in the
upper right corner, select Add
a Device, and select “Smartmi
2-in-1 Purifier and Humidifier”.
After adding the device, you
should see it on the front page
of the Mijia app.
Note: The machine will not turn on if the water level in
the tank is lower than the minimum water level. You will
have to add water to turn the machine on.
Note: You can turn the Air Dry mode on or off through
the Mijia app.
When the water level drops lower than 10%, the
humidifier will continue to operate for about 8 hours to
dry out the water tank, avoiding strange odors caused
by stagnant water.
If Air Dry mode is off:
When the water level drops lower than 10%, the
humidifier will automatically turn off.
Power / Mode BuonWi-Fi / Light Buon
On
On
Blinking Off
Off
Water Level < 10%
10% ≤ Water Level < 40%
40% ≤ Water Level < 60%
60% ≤ Water Level < 80%
80% ≤ Water Level < 100%
Water Level 100%
Over Max Water Level
Automatic Mode
Speed 1: Low
Speed 2: Medium
Speed 3: High
Automatic Mode: Automatically adjusts
humidifier based on current temperature
and humidity inside the room.
Speed 1: Low
Speed 2: Medium
Speed 3: High
Handling
Product Name Rated Voltage Capacity
Wi-Fi
Network
standby power
consumption
Humidification
Rate
Rated Frequency
Rated Waage
Noise Generated
Product Type
Model Number
Dimensions
Net Weight
Smartmi Evaporative
Humidifier
Installation
Power Cable Usage Restrictions
While in Use
Please turn off and disconnect the machine before moving it.
Please empty the water tank before moving the machine.
To avoid risk of fire, shock, or damage:
Please install the machine according to the instructions provided to avoid
electrical shock, fire, bodily harm, or other dangers.
Do not connect the power cable until you have finished seing up the
machine.
Plug the power cable into an appropriate socket.
Do not pull or stretch the power cable.
Disconnect the power cable before performing cleaning, maintenance, or
moving the machine.
If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
CAUTION: To comply with the limits of the Class B digital device, pursuant to Part 15 of the FCC Rules, this device is comply
with Class B limits. All peripherals must be shielded and grounded. Operation with non-certified peripherals or non-shielded
cables may results in interference to radio or reception.
MODIFICATION: Any changes or modifications not expressly approved by the grantee of this device could void the user’s
authority to operate the device.
FCC RF EXPOSURE STATEMENT:
This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
FCC ID: 2AP98-CJXJSQ02ZM
If the purifier is tilted, it may misread the water level in the tank, or cause
spills. Please ensure that the device is even before use.
This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision or instruc-
tion concerning use of the appliance in a safe way and understand the
hazards involved.
Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by children without
supervision.
Do not use under the following circumstances to avoid shock, fire, or other
dangers:
Wi-Fi Indicator Light
Intake Port
Power CableWater Level Detector
1
1
6 97
The Smartmi 2-in-1 Purifier and Humidifier humidifies using evaporation, so it won’t produce a visible mist.
8
If the product starts producing a strange sound, odor, or gets very hot,
cease use immediately.
Do not put your finger or other foreign objects inside the protective cover-
ing, intake port, exhaust port, or other movable parts.
Do not allow hair or loose threads to get caught in the intake or exhaust ports.
Do not sit or lean on the machine.
Ensure adequate ventilation when used alongside household gas appli-
ances (such as gas stoves or water heaters) to avoid carbon monoxide
poisoning.
If the alarm stops working, it may be caused by water accumulation in the
upper casing. It will not affect use. It should resume working normally after
the water has evaporated.
100-240V
240mL / hCJXJSQ02ZM 50/60Hz
Evaporative
Humidifier
240 240 363 mm 8W
Gross Weight
Approx. 4.3kg
Approx. 5.1kg
Max RF Output Power Wi-Fi 2.4 G (2400 - 2483.5 MHz): 17.6 dBm

47dB(A)
<
2.0W
Wi-Fi IEEE
802.11 b/g/n 2.4GHz
Approx. 4.0L
Manufacturer: Beijing Smartmi Electronic Technology Co., Ltd.
Address: 11-1102, Office Building Rainbow City, NO.68 Qinghe Mid-Street, Haidian District, Beijing
Smartmi Evaporative Humidifier
Read this manual carefully before use, and retain it for future reference
V-190515-Y
F
A
S
T
E
N
L
O
O
S
E
N
2
1
2
If your phone is unable to connect to the purifier,
press and hold both the Wi-Fi / Light buon and the
Power / Mode buon for 5 seconds. Once you hear
a beep, the Wi-Fi has been successfully reset.
Cleaning the Evaporating Basin
You can remove the evaporating basin and use a soft
cloth to wipe down, or clean water to rinse off the basin.
You can also twist off the knob on the evaporating basin
to clean the individual discs that comprise the basin.
As illustrated below, you can twist
off the knob on the basin to remove
the individual disks that comprise
the basin.
Turn the humidifier off and disconnect the power cable
before cleaning the device
32
Regulatory compliance information
Europe — EU declaration of conformity
We Beijing Smartmi Electronic Technology Co., Ltd. hereby, declares that this equipment is in
compliance with the applicable directives and european norms, and amendments
The full text of the EU declaration of conformity is available at the following internet address:
hp://smartmi.com.cn/doc.html
Disposal and recycling information
Correct disposal of this product. This marking indicates that this product should not be disposal with other household
wastes. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and
collection systems or contact the retailer where the product was purchased. They can take this product for environmental
safe recycling
  • Page 1
/

advertisement

Key Features

  • 4.0L water tank
  • Three operating modes: automatic, low, and high
  • Built-in Wi-Fi module for remote control
  • Compatible with the Mijia Smart Platform
  • Supports the MIUI system
  • Can connect with other Mijia smart devices

Related manuals

Frequently Answers and Questions

How do I add water to the Smartmi CJXJSQ02ZM?
You can add water to the Smartmi CJXJSQ02ZM through the refilling port or by removing the top half of the purifier and adding water directly to the tank.
How do I change the operating mode of the Smartmi CJXJSQ02ZM?
You can change the operating mode of the Smartmi CJXJSQ02ZM by pressing the Power / Mode button repeatedly.
How do I reset the Wi-Fi connection on the Smartmi CJXJSQ02ZM?
You can reset the Wi-Fi connection on the Smartmi CJXJSQ02ZM by pressing and holding both the Wi-Fi / Light button and the Power / Mode button for 5 seconds.

advertisement