Hairmax Actonis 18 LaserComb Quick Start Guide
advertisement
QUICK START
GUIDE
LQH018DAEDXXX 00 0723
LEXINGTON INTERNATIONAL, LLC
1040 Holland Drive | Boca Raton, Florida | 33487 | USA
www.actonis.com
Australian Sponsor:
Emergo Australia
Level 20, Tower II Darling Park,
201 Sussex Street Sydney,
NSW 2000 Australia
Authorized Representative in Europe
(Regulatory Affairs Only):
Tel: +31 (0) 70 345-8570 Fax: +31 70 346-7299
CUSTOMER SERVICE
TOLL-FREE NUMBERS
United States and Canada 1-866-527-3726
United Kingdom 0808-134-9868
Australia 61 7 3198 2484
France 805-081-824
Spain 900-838-164
Mexico 01 800 953 0209
Italy 800 694 205
Germany 800 001 0163
Or visit: www.actonis.com/usermanual
SCAN QR CODE
To access the full
user manual
You can also call customer service free of charge to request a hard copy
Westervoortsedijk 60
6827 AT Arnhem
The Netherlands
DUAL ACTION 18
LaserComb
LQH018DADXXX-00-0723.indd 1LQH018DADXXX-00-0723.indd 1 7/13/23 12:39 PM7/13/23 12:39 PM
GUIDE
LQH018DAEDXXX 00 0723
LEXINGTON INTERNATIONAL, LLC
1040 Holland Drive | Boca Raton, Florida | 33487 | USA
www.actonis.com
Australian Sponsor:
Emergo Australia
Level 20, Tower II Darling Park,
201 Sussex Street Sydney,
NSW 2000 Australia
Authorized Representative in Europe
(Regulatory Affairs Only):
Tel: +31 (0) 70 345-8570 Fax: +31 70 346-7299
CUSTOMER SERVICE
TOLL-FREE NUMBERS
United States and Canada 1-866-527-3726
United Kingdom 0808-134-9868
Australia 61 7 3198 2484
France 805-081-824
Spain 900-838-164
Mexico 01 800 953 0209
Italy 800 694 205
Germany 800 001 0163
Or visit: www.actonis.com/usermanual
SCAN QR CODE
To access the full
user manual
You can also call customer service free of charge to request a hard copy
Westervoortsedijk 60
6827 AT Arnhem
The Netherlands
DUAL ACTION 18
LaserComb
LQH018DADXXX-00-0723.indd 1LQH018DADXXX-00-0723.indd 1 7/13/23 12:39 PM7/13/23 12:39 PM
QUICK START GUIDE
ENGLISH
Laser Light - Avoid Direct Eye Exposure
ActonisTM laser devices are indicated to promote hair growth in females with Androgenetic alopecia who have Ludwig (Savin) Classifications I - II or frontal
patterns of hair loss and who have Fitzpatrick Skin Types I - IV.
To validate your warranty, register online at
www.actonis.com/warranty
Your Actonis device has a limited warranty against defects in materials or workmanship from Lexington International, LLC.
Items that are damaged or abused are not covered under the warranty and will be charged at their regular repair rates. Any
attempt to self-service your device, unless instructed by LEXINGTON INTERNATIONAL CUSTOMER SERVICE, will void your
warranty. Please refer to our website for complete warranty terms.
Dual Action 18 LaserComb
FOR MAXIMUM BENEFIT
:: Scalp should be freshly washed (hair can be wet, dry or damp)
:: Use your device prior to applying styling products (these can build up and impede the
laser light)
:: Regularly clean your device with a slightly moistened cloth. Do not use harsh detergents
or cleaning products on any part of your device
CHARGING OPTIONS
Charge your LaserComb for 2-3 hours before initial use
MINUTES MINUTES
Ultima 9 Ultima 12
minutes
8 3 times
per week
OPTION 1 Charge your device using the charging cradle and power
cord. Prior to placing your device in the cradle, make sure it is turned off
and the teeth face away from you. Plug the power cord into the cradle
and the other end into an electrical wall outlet.
L
OPTION 2 Charge your device by placing the power cord directly into
the device and the other end into an electrical wall outlet.
Turn on your device by pressing the power button (lower button) until
the power button light turns on. Next, press the laser button (upper
button) until it lights up. That means your device is ready for use.
The indicator light on the power button will flash during the charging process. Once
charging is complete, the light will stop flashing and remain on.
When the battery is fully charged, the indicator light will be on. As the battery power
diminishes, the light will blink slowly. When the battery is getting low and needs to be
recharged, the light will start to flash rapidly. When this happens, charge your device.
If your device needs to be recharged during your treatment, allow it to fully charge before
continuing.
Do not use your LaserComb while it is plugged into the power cord.
During use, the indicator light will indicate the battery level. A steady, non-flashing light
indicates the battery is full.
POWER BUTTON
LASER BUTTON
TREATMENT METHOD
After treatment, turn off your device by pressing the power button (lower button) until the
indicator light turns off. Store your device in the charging cradle for future use. You may
leave the power cord plugged into the charging cradle at all times.
NOTE: The Actonis Dual Action 18 LaserComb will turn off automatically after 8 minutes.
The Actonis Dual Action 18 LaserComb is manufactured using precision components and
should last for many years of normal use.
For detailed information about troubleshooting, proper use, warnings and cautions,
access the full user manual by scanning the QR code located on the back panel. Please
read the entire user manual before operating.
To start your treatment, place your device flat on your scalp so that
both rows of teeth are touching the scalp.
Start at your hairline. Move your device from front to back of scalp in
a slow combing motion, pausing every 1/2 inch (1 cm) for 4 seconds.
When your device is on, it will beep and vibrate every four (4) seconds.
This means that it’s time to move the your device to the next area of
the scalp. Do not lift your device off your scalp while combing from
front to back. If you wish to turn off the beep/vibration during the
treatment, press the top laser button again.
Continue in this manner from front to back and then side to side until
you cover your entire scalp with multiple passes. Repeat these passes
for the total treatment time of 8 minutes.
POWER BUTTON
LASER BUTTON
POWER BUTTON
LASER BUTTON
POWER BUTTON
LASER BUTTON
Prior to treatment, test your skin for sensitivity by shining the light on the inside of your
forearm for 2 minutes. If you see any reaction, do not use your device and contact customer
service.
LQH018DADXXX-00-0723.indd 2LQH018DADXXX-00-0723.indd 2 7/13/23 12:39 PM7/13/23 12:39 PM
ENGLISH
Laser Light - Avoid Direct Eye Exposure
ActonisTM laser devices are indicated to promote hair growth in females with Androgenetic alopecia who have Ludwig (Savin) Classifications I - II or frontal
patterns of hair loss and who have Fitzpatrick Skin Types I - IV.
To validate your warranty, register online at
www.actonis.com/warranty
Your Actonis device has a limited warranty against defects in materials or workmanship from Lexington International, LLC.
Items that are damaged or abused are not covered under the warranty and will be charged at their regular repair rates. Any
attempt to self-service your device, unless instructed by LEXINGTON INTERNATIONAL CUSTOMER SERVICE, will void your
warranty. Please refer to our website for complete warranty terms.
Dual Action 18 LaserComb
FOR MAXIMUM BENEFIT
:: Scalp should be freshly washed (hair can be wet, dry or damp)
:: Use your device prior to applying styling products (these can build up and impede the
laser light)
:: Regularly clean your device with a slightly moistened cloth. Do not use harsh detergents
or cleaning products on any part of your device
CHARGING OPTIONS
Charge your LaserComb for 2-3 hours before initial use
MINUTES MINUTES
Ultima 9 Ultima 12
minutes
8 3 times
per week
OPTION 1 Charge your device using the charging cradle and power
cord. Prior to placing your device in the cradle, make sure it is turned off
and the teeth face away from you. Plug the power cord into the cradle
and the other end into an electrical wall outlet.
L
OPTION 2 Charge your device by placing the power cord directly into
the device and the other end into an electrical wall outlet.
Turn on your device by pressing the power button (lower button) until
the power button light turns on. Next, press the laser button (upper
button) until it lights up. That means your device is ready for use.
The indicator light on the power button will flash during the charging process. Once
charging is complete, the light will stop flashing and remain on.
When the battery is fully charged, the indicator light will be on. As the battery power
diminishes, the light will blink slowly. When the battery is getting low and needs to be
recharged, the light will start to flash rapidly. When this happens, charge your device.
If your device needs to be recharged during your treatment, allow it to fully charge before
continuing.
Do not use your LaserComb while it is plugged into the power cord.
During use, the indicator light will indicate the battery level. A steady, non-flashing light
indicates the battery is full.
POWER BUTTON
LASER BUTTON
TREATMENT METHOD
After treatment, turn off your device by pressing the power button (lower button) until the
indicator light turns off. Store your device in the charging cradle for future use. You may
leave the power cord plugged into the charging cradle at all times.
NOTE: The Actonis Dual Action 18 LaserComb will turn off automatically after 8 minutes.
The Actonis Dual Action 18 LaserComb is manufactured using precision components and
should last for many years of normal use.
For detailed information about troubleshooting, proper use, warnings and cautions,
access the full user manual by scanning the QR code located on the back panel. Please
read the entire user manual before operating.
To start your treatment, place your device flat on your scalp so that
both rows of teeth are touching the scalp.
Start at your hairline. Move your device from front to back of scalp in
a slow combing motion, pausing every 1/2 inch (1 cm) for 4 seconds.
When your device is on, it will beep and vibrate every four (4) seconds.
This means that it’s time to move the your device to the next area of
the scalp. Do not lift your device off your scalp while combing from
front to back. If you wish to turn off the beep/vibration during the
treatment, press the top laser button again.
Continue in this manner from front to back and then side to side until
you cover your entire scalp with multiple passes. Repeat these passes
for the total treatment time of 8 minutes.
POWER BUTTON
LASER BUTTON
POWER BUTTON
LASER BUTTON
POWER BUTTON
LASER BUTTON
Prior to treatment, test your skin for sensitivity by shining the light on the inside of your
forearm for 2 minutes. If you see any reaction, do not use your device and contact customer
service.
LQH018DADXXX-00-0723.indd 2LQH018DADXXX-00-0723.indd 2 7/13/23 12:39 PM7/13/23 12:39 PM
advertisement
Related manuals
advertisement
