Troubleshooting. Bosch WTA4409GB/05, WTA4409GB/03, WTA4409GB/04, WTA4409GB/02, WTA4408GB/01, WTA4409GB/01

Troubleshooting...

Troubleshooting... Cause

The On indicator lamp does not light

The dryer is not plugged in. up.

No drying programme has been set.

The dryer does not start.

The circuit breaker has tripped.

Start button has not been pressed.

No drying programme has been set.

The door is not shut.

The ambient temperature is below 5 °C.

The room is not sufficiently ventilated.

The humidity in the room has increased significantly.

The door opens by itself.

The locking pin is not engaged.

Solution

Plug in the dryer.

Select the programme you require using the programme selector.

Reset/replace the fuse.

Press the button.

Select the programme you require using the programme selector.

Close the door.

Warm up the room.

Ensure sufficient ventilation.

Push the door closed until you hear the locking pin click into place.

Clean the filter (page 19). Drying is not satisfactory or the drying time is too long.

The filter is blocked.

21

Troubleshooting... Cause Solution

Drying is not satisfactory

Ambient temperature is above 30 °C.

Ensure that there is sufficient ventilation.

The wrong programme was selected.

Power cut for more than two hours.

Set the drying programme using the programme information (from page 16).

Restart the program by pressing the Start button again.

Laundry is not dried evenly

The laundry feels damper than it really is.

There was

- too much laundry.

- only large items of laundry.

- items of laundry with different fibre constructions.

Reset the drying time if the laundry is not sufficiently dry after cooling down.

Dry

- small amounts of laundry.

- large and small items together.

- items according to their fibre construction.

Condensation in the exhaust air hose.

The exhaust air hose is too long.

Arrange the dryer so that the exhaust air hose is no more than 2 m long.

!

Risk of electrocution

Repairs must only be carried out by the aftersales service or an authorised expert.

If you cannot rectify a fault yourself or a repair is necessary:

Turn the

programme selector

to

Off

.

Remove the plug from the socket.

Contact the aftersales service (see page 23).

22