- Home
- Domestic appliances
- Large home appliances
- Tumble dryers
- Bosch
- WTA76200IN/07
- Instruction manual
- 10 Pages
Optional accessories. Bosch WTA76200IN/07
advertisement
Assistant Bot
Need help? Our chatbot has already read the manual and is ready to assist you. Feel free to ask any questions about the device, but providing details will make the conversation more productive.
Care and cleaning
Only when the appliance is switched off.
Dryer housing and control panel
– Wipe clean with a soft, damp cloth.
– Do not clean with a water jet.
– Remove detergent and cleaning agent residue immediately.
Exhaust air duct
a
Exhaust air duct installation instruction
.
Check the exhaust air duct as it may be clogged.
Clean the exhaust air duct at regular intervals, e.g. every six months.
Do not bend the exhaust air duct.
1.
Switch off the dryer and allow it to cool down.
2.
Disconnect the mains plug.
3.
Remove the exhaust air duct.
4.
Clean the exhaust air duct.
5.
Refit the exhaust air duct.
Moisture sensors
The dryer is equipped with stainless steel moisture sensors.
Moisture sensors measure the moisture level of the laundry.
After sustained, repeated operation, a fine layer of limescale may form on the moisture sensors.
1.
Open the door.
2.
Clean the moisture sensors with a damp sponge which has a rough surface.
Do not use steel wool or abrasive agents!
8
Installation
– Scope of delivery: dryer, operating and installation instructions, basket for woollens
(depending on the model)
.
– Check the dryer for transport damage.
– The dryer is very heavy. Do not attempt to lift it on your own.
– Be careful to avoid sharp edges.
– Do not lift the dryer by protruding parts (e.g. the door) - risk of breakage.
– Do not set up in a room that is susceptible to frost.
Freezing water may cause damage.
– If in doubt, have the appliance connected by a specialist.
1.
Setting up the dryer
– The mains plug must always be accessible.
– Ensure that the appliance is placed on a clean, level and firm surface.
– Install the exhaust air duct a
Exhaust air duct installation instruction
.
– Keep the area around the dryer clean.
– Level the dryer using the threaded feet and a spirit level.
Never remove the threaded feet!
Take all accessory parts out of the drum.
The drum must be empty.
Do not install the dryer behind a door or sliding door which could prevent or obstruct the dryer door from opening.
This will prevent children from locking themselves in and risking their lives.
Clean and level.
2.
For mains connection,
see Safety instructions
a
page 13.
– Connect to an AC earthed socket. If in doubt have the socket checked by a specialist.
– The mains voltage and the voltage shown on the rating plate ( a
page 10
) must be the same.
– The connected load and necessary fuse protection are specified on the rating plate.
9
Optional accessories
(order from the after-sales service using the order number, according to model)
WTZ
1130
Exhaust air duct set
The exhaust air is extracted via a hose.
WTZ
11311
WMZ
20500
Washer-dryer stack connection set
The dryer can be placed on top of a suitable washing machine with the same width and depth to save space. The dryer must be fastened to the washing machine using this connection set. If the worktop of the washing machine is less than 544 mm deep, please consult the after-sales service or your specialist retailer.
Platform
For easier loading and unloading. The basket contained in the drawer can be used to carry the laundry.
Technical data
ʠ
Dimensions (DxWxH)
Weight
Max. capacity
Connection voltage
Connected load
Fuse protection
Ambient temperature
60 x 60 x 85 cm (height adjustable) approx. 36 kg
7 kg
220-240 V
2200 W
10 A
5 - 35°C
Product number
Production number
Inside of door
The rating plate can be found on the back of the dryer.
Consumption rates
Fabrics/programmes
Residual moisture in the fabrics after spinning
Drying time**
Energy consumption**
L
Cottons 7 kg
+
. Cupboard Dry* 1400 rpm
1000 rpm
800 rpm
(50%)
(60%)
(70%)
107 min
128 min
149 min
3.16 kWh
3.95 kWh
4.60 kWh
|
Iron Dry* 1400 rpm
1000 rpm
800 rpm
(50%)
(60%)
(70%)
83 min
99 min
116 min
1.96 kWh
2.92 kWh
3.63 kWh
I
Easy-Care 3.5 kg
+
. Cupboard Dry* 800 rpm
600 rpm
(40%)
(50%)
47 min
59 min
1.32 kWh
1.72 kWh
* Programme setting for testing in accordance with applicable standard DIN EN61121.
** The values may differ from those specified, depending on the type of fabric, composition of laundry to be dried, residual moisture in the fabric, the degree of dryness that has been set, the amount of laundry being loaded and the environmental conditions.
Fabrics/programmes Drying time Annual energy consumption
L
Cottons 7 kg / 3.5
ü kg *
+
. Cupboard Dry*** 97 min / cycle 482
ü kWh / year
***Programme setting for testing and energy labelling in accordance with Directive 2010/30/EU.
10
After-sales service
If you cannot rectify the fault yourself (e.g. switching off/on) a
What to do if..., page 11/12
, please contact our after-sales service. We will always find an appropriate solution and avoid unnecessary visits by engineers.
The contact details of your local after-sales service can be found in the enclosed after-sales service directory.
– GB 0344 892 8979 (Calls charged at local or mobile rate.)
– IE 01450 2655 (0.03 € per minute at peak. Off peak 0.0088 € per minute.)
Please provide the after-sales service the product number (E no.) and the production number
(FD) of the appliance.
Product number Production number
You can find this information: inside the door* / in the opened service flap* and on the rear of the appliance.
*depending on the model
Trust the expertise of the manufacturer. Contact us for assistance. In this way, you can rest assured that the repair will be carried out by trained service technicians using original spare parts.
What to do if ...
Turn the programme selector to Off and remove the mains plug from the socket.
ʠ
The
$
Start /Pause indicator light does not light up.
Mains plug plugged in?
Programme selected?
Check the socket fuse.
ʠ
The display panel light and indicator lights
(depending on model)
go out and the
$
Start /Pause indicator light flashes.
ʠ
Dryer does not start.
Energy-saving mode is activated a
see the separate
Energy-saving mode
instructions.
ʠ
The display panel switches off.
The appliance goes into the sleep mode after activating
È
Finished in option a
page 5
.
ʠ p
(Fluff filter/Exhaust air duct) indicator light flashes.
Clean the fluff filter a
page 4.
Press the
$
Start /Pause button to reset the displayed indication and then press the
$
Start
/Pause button again to restart the appliance if necessary.
Exhaust air duct blocked or bent?
Clean the exhaust air duct a
page 8.
If necessary, clean the insect screen on the exhaust air pipe.
$
Start /Pause button selected? Door closed?
Ambient temperature greater than 5°C? The optimum ambient temperature for drying is between
5°C and 35°C ʠ
Programme terminates shortly after starting.
Is the appliance loaded with the laundry?
Load too small for selected programme?/Use timed programme a
page 6/7.
Loaded laundry dry?
ʠ
Water is leaking out.
Make sure the dryer is level.
11
What to do if ...
ʠ
The door opens by itself.
ʠ
Drying result is not satisfactory
(laundry feels too damp).
Push the door closed until you hear it engage.
ʠ ʠ
Drying time too long.
ʠ
One or more indicator lights are flashing.
ʠ ʠ
The humidity in the room increases.
Power failure.
Condensation in the exhaust air duct.
Warm laundry feels damper than it really is.
The selected programme does not suit the load. Use another drying programme or, in addition, select the timed programme a
page 7.
Dryer installed too closely to other objects? Provide adequate air circulation.
Use y
Fine adjust for the dryness levels a
page 5.
Fine layer of limescale on the humidity sensors a
Clean the moisture sensors a
page 8
.
Programme termination, e.g. mains power supply failure, door open or maximum drying time reached?
Clean the fluff filter under running water a
page 4.
Insufficient supply of air a
Ensure that air can circulate.
Ambient temperature greater than 35°C a
Ventilate the room. The optimum ambient temperature for drying is between 5°C and 35°C. Outside of this range, the drying time may increase.
Make sure the room is sufficiently ventilated.
Exhaust air duct installed/the exhaust air routes directly into the open air? a
Installation instructions for exhaust air duct, page 1.
Clean the fluff filter a
page 4/11
.
Check the installation conditions a
page 9.
Exhaust air duct blocked or bent?
Clean the exhaust air duct a
page 8.
Switch off, allow to cool, switch back on, and restart the programme.
Remove the laundry from the dryer immediately and spread out. This allows the heat to dissipate. Be careful as the door, the drum and the laundry may be hot.
Exhaust air duct too long? Check the maximum exhaust air duct length. Further information a
Installation instructions for exhaust air duct
.
12
Safety instructions
Emergency – Pull the mains plug out of the socket immediately or disconnect the fuse.
ONLY use the dryer...
– in rooms inside the house.
– for drying fabrics.
The dryer must
NEVER...
– be used for purposes other than those described above.
– be modified in terms of its technology or attributes.
Dangers – The dryer must not be used by children or persons who have not been instructed in its use.
– Do not leave children unsupervised near the dryer.
– Keep pets away from the dryer.
– Remove all objects from the pockets of garments. Pay particular attention to cigarette lighters a
Risk of explosion.
– Do not lean or sit on the door a
Risk of tipping.
– Open the door with care. Hot steam may escape.
Installation – Fasten down loose leads a
Risk of tripping
– Do not operate the dryer where there is a risk of frost.
– The safety information in the separate installation instructions for the exhaust air duct must be observed without fail.
Mains connection
– Connect the dryer to an AC earthed socket according to specifications, as otherwise it cannot be guaranteed that the appliance is completely safe.
– The cable cross-section must be sufficient.
Operation
Defect
– Only use earth-leakage circuit breakers with the following symbol:
– The mains plug and socket must be compatible.
– Do not use multiple plugs/couplings and/or extension cables.
– Do not touch or hold the mains plug with wet hands a
Risk of electric shock.
– Never pull the mains plug out of the socket by its cable.
– Do not damage the mains lead a
Risk of electric shock.
– Only load the drum with items of laundry. Check what has been loaded before switching the dryer on.
– Do not use the dryer if the laundry has been in contact with solvents, oil, wax, grease or paint (e.g. hair spray, nail polish remover, stain remover, cleaning solvent, etc.) a
Risk of fire/explosion.
– The tumble dryer is not to be used if industrial chemicals have been used for cleaning.
– Dust risk (e.g. coal dust or flour): do not use the dryer a
Risk of explosion.
– Do not turn off the dryer until the drying process ends, unless the laundry will be removed quickly and spread out, so that the heat can dissipate.
– Do not put laundry containing foamed material/rubber in the dryer a
elastic material may be destroyed and the dryer may be damaged due to possible deformation of the foamed material.
– Final part of a tumble dryer cycle occurs without heat (cool down cycle), to ensure that the items are left at a temperature that ensures that the items will not be damaged.
– Switch off the dryer once the programme has ended.
– Do not use the dryer if it is defective or if you suspect that it is.
Repairs must only be carried out by the after-sales service.
– Do not use the dryer with a faulty mains cable. In order to avoid danger, have the mains lead replaced only by our after-sales service.
Spare parts – For safety reasons, you must only use genuine spare parts and accessories.
Disposal
– Dryer: Disconnect the mains plug, then
cut the mains cable off the appliance.
Dispose of the appliance at a municipal waste disposal site.
– Packaging: Do not allow children access to items of packaging a
Risk of suffocation.
– All materials are environmentally friendly and reusable. Dispose of them in an environmentally responsible manner.
13
Dryer
WTA76200IN en
Instruction manual
advertisement
Related manuals
advertisement
Table of contents
- - Preparation
- - Control panel
- - Drying
- - Display panel and settings
- - Notes on laundry
- - Overview of programmes
- - Care and cleaning
- 1 Installation
- 2 Optional accessories
- 2 Technical data
- 2 Consumption rates
- 3 After-sales service
- 4 What to do if
- 5 Safety instructions
- - Preparation
- - Control panel
- 2 Drying
- 3 Display panel and settings
- 4 Notes on laundry
- 5 Overview of programmes
- 6 Care and cleaning
- 7 Installation
- 8 Optional accessories
- 8 Technical data
- 8 Consumption rates
- 9 After-sales service
- 10 What to do if
- 9 Safety instructions