Installation. Bosch WTA76200IN/07

Installation. Bosch WTA76200IN/07
Add to My manuals

advertisement

Assistant Bot

Need help? Our chatbot has already read the manual and is ready to assist you. Feel free to ask any questions about the device, but providing details will make the conversation more productive.

Manual
Installation. Bosch WTA76200IN/07 | Manualzz

Care and cleaning

Only when the appliance is switched off.

Dryer housing and control panel

– Wipe clean with a soft, damp cloth.

– Do not clean with a water jet.

– Remove detergent and cleaning agent residue immediately.

Exhaust air duct

a

Exhaust air duct installation instruction

.

Check the exhaust air duct as it may be clogged.

Clean the exhaust air duct at regular intervals, e.g. every six months.

Do not bend the exhaust air duct.

1.

Switch off the dryer and allow it to cool down.

2.

Disconnect the mains plug.

3.

Remove the exhaust air duct.

4.

Clean the exhaust air duct.

5.

Refit the exhaust air duct.

Moisture sensors

The dryer is equipped with stainless steel moisture sensors.

Moisture sensors measure the moisture level of the laundry.

After sustained, repeated operation, a fine layer of limescale may form on the moisture sensors.

1.

Open the door.

2.

Clean the moisture sensors with a damp sponge which has a rough surface.

Do not use steel wool or abrasive agents!

8

Installation

– Scope of delivery: dryer, operating and installation instructions, basket for woollens

(depending on the model) .

– Check the dryer for transport damage.

– The dryer is very heavy. Do not attempt to lift it on your own.

– Be careful to avoid sharp edges.

– Do not lift the dryer by protruding parts (e.g. the door) - risk of breakage.

– Do not set up in a room that is susceptible to frost.

Freezing water may cause damage.

– If in doubt, have the appliance connected by a specialist.

1.

Setting up the dryer

– The mains plug must always be accessible.

– Ensure that the appliance is placed on a clean, level and firm surface.

– Install the exhaust air duct a

Exhaust air duct installation instruction .

– Keep the area around the dryer clean.

– Level the dryer using the threaded feet and a spirit level.

Never remove the threaded feet!

Take all accessory parts out of the drum.

The drum must be empty.

Do not install the dryer behind a door or sliding door which could prevent or obstruct the dryer door from opening.

This will prevent children from locking themselves in and risking their lives.

Clean and level.

2.

For mains connection,

see Safety instructions a

page 13.

– Connect to an AC earthed socket. If in doubt have the socket checked by a specialist.

– The mains voltage and the voltage shown on the rating plate ( a page 10 ) must be the same.

– The connected load and necessary fuse protection are specified on the rating plate.

L

+

|

I

+ ʠ

9

L

+

ü

ü a ʠ ʠ ʠ ʠ

$ ʠ

$ ʠ ʠ p

È

$ a a a

$

$ a a ʠ ʠ ʠ ʠ ʠ ʠ ʠ a y a a a a a a a a a a a a a a a a a a a a

advertisement

Related manuals