Troubleshooting guide. Groupe Brandt DRN1215J, DRP831JEC

Add to My manuals
28 Pages

advertisement

Troubleshooting guide. Groupe Brandt DRN1215J, DRP831JEC | Manualzz

Troubleshooting guide

Fault: Cause/Remedy

The appliance does not operate after connection to the

• Check if there is power in the socket and if the appliance is

switched on.

mains:

Cooling system operates continuously without intermittent stoppages:

• Ambient temperature too high.

• Frequent opening of the door, door open too long.

• Door not closed properly (particle between door gasket, sagged

door, check gasket sealing, etc...).

• Excessive quantity of fresh food inserted at once.

• Refrigerator probe (A) is clogged with fresh food. Relocate the

food to provide air circulation around the probe (certain models

only).

• Check air circulation for suffi cient cooling of the compressor, and

clean the condenser.

Excessive ice formation at the rear interior wall of the freezer:

• Frequent opening of the door, door open too long.

• Inserting hot food in the freezer.

• Food or dish is touching the rear interior panel of the refrigerator.

• Bad door sealing; clean or replace the gasket if dirty or damaged.

Water dripping from the appliance:

• Drain outlet is clogged, drain water drips past the collection

groove.

• Clean the clogged outlet using plastic straw.

• Thaw thick ice deposits manually (see chapter Defrosting).

Red signal light fl ashing (only freezer):

Diffi cult door opening:

•Frequent opening of the door, door open too long.

• Door not closed properly (particle between door gasket, sagged

door, damaged gasket, etc...).

• Excessively long power failure.

• Excessive quantity of fresh food inserted at once.

• If you attempt to open the immediately closed door of the freezer you may experience resistance. This happens because certain quantity of cold air escapes from the appliance through the open door and is replaced by warm ambient air. Cooling of such air creates negative pressure (vacuum) and suction, which prevents easy opening of the door. Situation is normalized after a few minutes (5-10), and you can open the door with ease.

25

Fault: Cause/Remedy

Bulb replacement: • Before replacing the light bulb, disconnect the appliance form the

power supply (pull the power cord from the wall socket).

A – Use the screwdriver to press the locking hook (in arrow

direction), and remove the cover.

B – Insert the screwdriver into the cover slot, lift it and remove the

cover.

Replace the bulb with the equivalent new bulb (E 14, same voltage as the original one) and replace the cover back to its position.

• Don’t forget: the old bulb does not belong to organic waste.

• Light bulb is consumption material and is not covered by the warranty!

Helpful hints • If none of the above proves effective and you can not remove

the fault yourself, disconnect the appliance from the mains ( see

chapter regarding the ON/OFF function), pull the power cord from

the wall socket, wait for approximately 10 minutes and reconnect

the appliance.

If the fault persists call the nearest service center and tell them

the information from the rating plate: type of appliance, model and

serial number, located inside the appliance.

26

advertisement

Key Features

  • Top part is refrigerator, Bottom part is upright freezer
  • NO FROST version of the freezer, fitted with the fan and featuring automatic defrosting
  • FRESH ZONE compartment for preserving the freshness of fruits and vegetables

Related manuals

Frequently Answers and Questions

What are the dimensions of the appliance?
The manual does not specify the dimensions of the appliance.
What is the total capacity of the appliance?
The manual does not specify the total capacity of the appliance.
What is the noise level of the appliance?
The manual does not specify the noise level of the appliance.