Troubleshooting guide. Groupe Brandt DRS1024J, DRS1022J

Add to My manuals
24 Pages

advertisement

Troubleshooting guide. Groupe Brandt DRS1024J, DRS1022J | Manualzz

Troubleshooting guide

Fault:

The appliance does not operate after connection to the mains:

Cooling system operates continuously without intermittent stoppages:

Excessive ice formation at the rear interior wall of the freezer:

Water dripping from the appliance:

Bulb replacement:

Helpful hints

Cause/Remedy

• Check if there is power in the socket and if the appliance is

switched on.

• Ambient temperature too high.

• Frequent opening of the door, door open too long.

• Door not closed properly (particle between door gasket, sagged

door, check gasket sealing, etc...).

• Excessive quantity of fresh food inserted at once.

• Refrigerator probe (A) is clogged with fresh food. Relocate the

food to provide air circulation around the probe (certain models

only).

• Check air circulation for suf fi cient cooling of the compressor, and

clean the condenser.

• Frequent opening of the door, door open too long.

• Inserting hot food in the freezer.

• Food or dish is touching the rear interior panel of the refrigerator.

• Bad door sealing; clean or replace the gasket if dirty or damaged.

• Drain outlet is clogged, drain water drips past the collection

groove.

• Clean the clogged outlet using plastic straw. If you have an appliance with the ZERO’N’FRESH drawer, call servis.

• Thaw thick ice deposits manually (see chapter Defrosting).

• Before replacing the light bulb, disconnect the appliance form the power supply (pull the power cord from the wall socket).

B – Insert the screwdriver into the cover slot, lift it and remove

the cover.

Replace the bulb with the equivalent new bulb (E 14, same voltage as the original one) and replace the cover back to its position.

• Don’t forget: the old bulb does not belong to organic waste.

• Light bulb is consumption material and is not covered by the warranty!

• If none of the above proves effective and you can not remove

the fault yourself, disconnect the appliance from the mains ( see

chapter regarding the ON/OFF function), pull the power cord from the wall socket, wait for approximately 10 minutes and reconnect the appliance.

If the fault persists call the nearest service center and tell them

the information from the rating plate: type of appliance, model

and serial number, located inside the appliance.

20

advertisement

Key Features

  • Electronically regulated temperature control for precise cooling.
  • Spacious refrigerator compartment with adjustable shelves and door balconies for flexible storage.
  • Dedicated ZERO'N'FRESH compartment for preserving the freshness and flavor of delicate foods.
  • Four-star freezer compartment for efficient freezing and long-term food storage.
  • Reversible door hinge for convenient placement in any kitchen layout.
  • Self-closing shear door hinge for gentle and secure door closure.

Related manuals

Frequently Answers and Questions

What is the purpose of the ZERO'N'FRESH compartment?
The ZERO'N'FRESH compartment maintains a slightly cooler temperature than the refrigerator, creating an ideal environment for preserving the freshness and flavor of delicate foods like fruits, vegetables, and meats.
Can I adjust the temperature of the refrigerator and freezer compartments?
Yes, the DRS1022J features electronical temperature regulation, allowing you to set and adjust the temperature of both compartments independently for optimal food storage.
How do I change the direction of the door opening?
Refer to the 'Changing the Direction of Opening the Door' section in the instruction manual for detailed steps on how to reverse the door hinge.