Installation and connections. Groupe Brandt KGIT122FD

Add to My manuals
24 Pages

advertisement

Installation and connections. Groupe Brandt KGIT122FD | Manualzz

Installation and connections

• Place the appliance in dry and well aired room. The appliance operates best at temperature ranges indicated in the chart below. Relevant class of the appliance is indicated on the rating plate.

Class

SN (subnormal)

N (normal)

ST (subtropical)

T (tropical)

Ambient temperature

from + 10°C to + 32°C from + 16°C to + 32°C from + 16°C to + 38°C from + 16°C to + 43°C

Positioning the appliance requires two persons in order to avoid injuries or damage to the appliance.

• Place the appliance fl atly and fi rmly on a solid base. The appliance is fi tted with adjustable feet on the front side, used to level the appliance (certain models only).

• Avoid exposing the appliance to direct sunlight or heat sources. If this is not feasible, install insulation plate between the appliance and adjacent heat source.

• The appliance may stand independently or you may incorporate it into the kitchen cabinet. Be sure to leave enough space for cooling of condenser (distance from the wall or the opening should be 200 cm 2 ). Distance to the cabinet above the appliance should be at least 5 cm.

After the installation, the appliance mains plug should be accessible!

7

8

• The appliance is fi tted with spacers to be mounted on the top edge of the condenser. They prevent the rear of the appliance to be pushed too close to the wall. Spacers are fabricated universally regarding the different distance of the condenser from the cabinet, so make sure to position them properly.

• Use the power cord to connect the appliance to the mains power. Wall outlet must be fi tted with ground terminal (safety socket). Required nominal voltage and frequency are indicated on the relevant label or rating plate of the appliance.

• Mains power connection and grounding must be made in line with standing regulations and local requirements.

The appliance is able to accommodate minor temporary voltage tolerances, but they may not exceed -6% to +6%.

advertisement

Related manuals

Frequently Answers and Questions

What is the recommended temperature setting for the appliance?
The recommended thermostat knob setting for most refrigerators is to the ECO position, unless the room temperature is lower than 16°C, in which case it should be set to Max.
What is the SF/SC position on the control panel?
SF stands for "Super frost" and indicates fast freezing, while SC stands for "Super cool" and indicates fast cooling.
How do I change the direction of the door opening?
Tilt the appliance, unscrew the bottom hinge, disassemble as shown in Figure 3 of the manual, then reassemble the parts in the opposite turn, using the attached opposite hinge insert piece.
What should I do if the door seal does not rest well?
Remove the door seal and turn it by 180°.
How does the appliance temperature get set?
The appliance temperature is set by turning the button (B) on the control panel to the position between the Min and Max span.