regulation. Groupe Brandt KGIT122FD

Add to My manuals
24 Pages

advertisement

regulation. Groupe Brandt KGIT122FD | Manualzz

Control panel - appliance with electronical regulation

CONTROL UNIT I

CONTROL UNIT II

A Digital temperature display

(certain models only) of the refrigerator indicates actual temperatures during the operation from +1°C to +9°C.

B ON/OFF and temperature setting button

C Orange LED:

illuminated during fan operation (knob D).

D Fast freeze fan activation knob

The appliance is switched on by turning the button (B) towards

Max

, and accordingly switched off when the arrow (small triangle) on the button points to the ON/OFF mark (the appliance, however, is still under mains power).

10

• Temperature of the appliance is set by turning the button (B) to the position between the

Min

and

Max

span.

• Recommended setting of the thermostat knob is to

ECO

position.

• If the room temperature, in which the appliance is installed, is lower than 16°C, the recommended setting of the thermostat knob is to the

Max

.

• In case of exceptionally higher ambient temperatures it is recommended to switch the fan operation at high speed by pressing button (D) – only for models featuring control panel 1.

SF/SC

position

- SF position stands for “Super frost” and indicates fast

freezing (certain models only).

- SC position stands for “Super cool” and indicates fast

cooling (certain models only).

• In apliances with digital display the indicator fl ashes during the setting procedure, and the beep signals each change of preset temperature. When fl ashing stops the fi nal setting is stored in memory.

• When the appliance is switched on, the display (A) will fl ash for a few seconds – the set value will be indicated. After a while, the actual or maximum value is indicated. This value will remain on the display until the actual temperature in the refrigerator compartment falls below the displayed level.

Fan assisted fast cooling is started by pressing the button (D).

Orange LED is on. Fan eliminates minor temperature differences between different cabinet spaces, and reduces dew formation on the interior surface of the appliance.

The alarm sounds if the refrigerator door is left open for more than 1 minute. When the door is closed again the alarm stops.

11

advertisement

Related manuals

Frequently Answers and Questions

What is the recommended temperature setting for the appliance?
The recommended thermostat knob setting for most refrigerators is to the ECO position, unless the room temperature is lower than 16°C, in which case it should be set to Max.
What is the SF/SC position on the control panel?
SF stands for "Super frost" and indicates fast freezing, while SC stands for "Super cool" and indicates fast cooling.
How do I change the direction of the door opening?
Tilt the appliance, unscrew the bottom hinge, disassemble as shown in Figure 3 of the manual, then reassemble the parts in the opposite turn, using the attached opposite hinge insert piece.
What should I do if the door seal does not rest well?
Remove the door seal and turn it by 180°.
How does the appliance temperature get set?
The appliance temperature is set by turning the button (B) on the control panel to the position between the Min and Max span.