Troubleshooting guide. Groupe Brandt KGIT122FD

Add to My manuals
24 Pages

advertisement

Troubleshooting guide. Groupe Brandt KGIT122FD | Manualzz

Troubleshooting guide

Fault: Cause/Remedy

The appliance does not operate after connection to the mains:

• Check if there is power in the socket and if the appliance is

switched on.

Cooling system operates continuously without intermittent stoppages:

• Ambient temperature too high.

• Frequent opening of the door, door open too long.

• Door not closed properly (particle between door gasket, sagged

door, check gasket sealing, etc...).

• Excessive quantity of fresh food inserted at once.

• Refrigerator probe (A) is clogged with fresh food. Relocate the

food to provide air circulation around the probe (certain models

only).

• Check air circulation for suf fi cient cooling of the compressor, and

clean the condenser.

Excessive ice formation at the rear interior wall of the freezer:

• Frequent opening of the door, door open too long.

• Inserting hot food in the freezer.

• Food or dish is touching the rear interior panel of the refrigerator.

• Bad door sealing; clean or replace the gasket if dirty or damaged.

Water dripping from the appliance:

• Drain outlet is clogged, drain water drips past the collection

groove.

• Clean the clogged outlet using plastic straw.

• Thaw thick ice deposits manually (see chapter Defrosting).

Bulb replacement:

Helpful hints

• Before replacing the light bulb, disconnect the appliance form the

power supply (pull the power cord from the wall socket).

B – Insert the screwdriver into the cover slot, lift it and remove

the cover.

Replace the bulb with the equivalent new bulb (E 14, same voltage as the original one) and replace the cover back to its position.

• Don’t forget: the old bulb does not belong to organic waste.

• Light bulb is consumption material and is not covered by the warranty!

• If none of the above proves effective and you can not remove

the fault yourself, disconnect the appliance from the mains ( see

chapter regarding the ON/OFF function), pull the power cord from

the wall socket, wait for approximately 10 minutes and reconnect

the appliance.

If the fault persists call the nearest service center and tell them

the information from the rating plate: type of appliance, model

and serial number, located inside the appliance.

21

advertisement

Related manuals

Frequently Answers and Questions

What is the recommended temperature setting for the appliance?
The recommended thermostat knob setting for most refrigerators is to the ECO position, unless the room temperature is lower than 16°C, in which case it should be set to Max.
What is the SF/SC position on the control panel?
SF stands for "Super frost" and indicates fast freezing, while SC stands for "Super cool" and indicates fast cooling.
How do I change the direction of the door opening?
Tilt the appliance, unscrew the bottom hinge, disassemble as shown in Figure 3 of the manual, then reassemble the parts in the opposite turn, using the attached opposite hinge insert piece.
What should I do if the door seal does not rest well?
Remove the door seal and turn it by 180°.
How does the appliance temperature get set?
The appliance temperature is set by turning the button (B) on the control panel to the position between the Min and Max span.