advertisement
PREPARATION
CONNECTIONS
Connecting speakers and source components
CAUTION
• Do not connect this unit or other components to the main power until all connections between components are complete.
• All connections must be correct: L (left) to L, R (right) to R, “+” to “+” and “–” to “–”. If the connections are faulty, no sound will be heard from the speakers, and if the polarity of the speaker connections is incorrect, the sound will be unnatural and lack bass. Refer to the owner’s manual for each of your components.
• Use RCA cables for audio components (except for speaker connections and DOCK jack connections).
Turntable
DVD player, etc.
CD recorder, etc.
DOCK jack connections
Speakers A
Audio out
GND Audio out
Audio out
Audio in
Audio out
Audio out
Audio in
Audio out
CD player Tuner Tape deck, etc.
Subwoofer Speakers B
y
• The PHONO jacks are designed for connecting a turntable with an MM cartridge.
• Connect your turntable to the GND terminal to reduce noise in the signal. However, for some turntables, you may hear less noise without the GND connection.
5
En
CONNECTIONS
CAUTION
• Do not let the bare speaker wires touch each other or any metal part of this unit. This could damage this unit and/or the speakers.
• Do not connect this unit or other components to the main power until all connections between components are complete.
1
Remove approximately 10 mm (3/8 in) of insulation from the end of each speaker cable and twist the exposed wires of the cable together to prevent short circuits.
10 mm (3/8 in)
■
Bi-wire connection
Bi-wire connection separates the woofer from the combined midrange and tweeter section. A bi-wire compatible speaker has four binding post terminals. These two sets of terminals allow the speaker to be split into two independent sections. With these connections, the mid and high frequency drivers are connected to one set of terminals and the low frequency driver to another set of terminals.
This unit
Speaker
2
Connect the speaker cable.
1
Unscrew the knob.
2
Insert one bare wire into the hole in the side of each terminal.
3
Tighten the knob to secure the wire.
Red: positive (+)
Black: negative (–)
■
Connecting via banana plug
Tighten the knob and then insert the banana plug into the end of the corresponding terminal.
Banana plug
Connect the other speaker to the other set of terminals in the same way.
CAUTION
When making bi-wire connections, set the IMPEDANCE
SELECTOR switch to HIGH or LOW depending on the impedance of your speakers:
6 Ω or higher: HIGH
4
Ω
or higher: LOW
See page 4 for more information about the IMPEDANCE
SELECTOR switch.
Note
When making bi-wire connections, remove the shorting bridges or cables on the speaker.
y
To use the bi-wire connections, switch the SPEAKERS selector to the A+B position.
6
En
Connecting the power cable
POWER
MANAGEMENT
CONNECTIONS
To the wall outlet with the power cable
■
POWER MANAGEMENT switch
Enables or disables the automatic power down function.
When the automatic power down function is enabled, this unit will automatically switch to standby mode if no operations are performed for 8 hours.
■
Connecting the power cable
Plug the power cable into the wall outlet after all other connections are complete.
7
En
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project