Dahua Network Camera Web 3.0 Operation Manual
Figure 6-32
6.2.3 PPPoE
The PPPoE interface is shown as in
Figure 6-33
.
Enter the PPPoE username and password which are provided by ISP (Internet Service Provider), and click “Enable”. The network camera will automatically establish network connection in the mode of
PPPoE after it is enabled; after it is successful, the IP of the “IP Address” will be automatically modified into the dynamic IP address of the acquired WAN.
Note:
After PPPoE dial-up is successful, it needs to log in the device via the IP which is set before dial-up; in the PPPoE setup interface, it will display the registered IP address, and then it can visit the IP address via client.
Please disable UPnP when clicking PPPoE enable, which is to avoid causing influence to PPPoE dialup.
51
Dahua Network Camera Web 3.0 Operation Manual
Figure 6-33
6.2.4 DDNS
The DDNS interface is shown as in
Figure 6-34
.
The DDNS is to set to connect the various servers so that you can access the system via the server.
Please go to the corresponding service website to apply a domain name and then access the system via the domain. It works even your IP address has changed. When the device connects to WLAN, you should disable UPnP.
Figure 6-34
Please refer to the following sheet for detailed information.
52
Dahua Network Camera Web 3.0 Operation Manual
Parameter Description
Server Type You can select DDNS protocol from the dropdown list: CN99
DDNS, NO-IP DDNS, Dyndns DDNS, and Dahua DDNS. The default is Dahua DDNS.
Server Address DDNS server IP address
CN99 DDNS
Server address: www.3322.org
NO-IP DDNS
Server address: dynupdate.no-ip.com
Dyndns DDNS
Server address: members.dyndns.org
Dahua DDNS
Server address
： www.dahuaddns.com
Mode Default is auto, able to choose manual
Domain Name Both auto and manual are “MAC addresss.dahuaddns.com”by default, able to set prefix manually.
Username The user name you input to log in the server, optional.
The CN99 DDNS interface is shown as in
Figure 6-35
.
Figure 6-35
53
