USING OTHER INSTALLED DRIVERS. Olivetti D-COPIA 150, d-Copia 120/150

Add to my manuals
78 Pages

advertisement

USING OTHER INSTALLED DRIVERS. Olivetti D-COPIA 150, d-Copia 120/150 | Manualzz

44

USING OTHER INSTALLED DRIVERS

If you use another GDI printer or a Windows Printing System printer, interference between printers may occur and printing may not be performed properly.

To use another GDI printer or a Windows Printing System printer, you must change the port setting of the printer driver using the following procedure.

If another printer does not operate properly when the Olivetti Personal

MFP Series printer driver is set to "FILE" as described below, uninstall the Olivetti Personal MFP Series printer driver. To uninstall the printer driver, see the online manual.

1

Click the "start" button.

2

Click "Control Panel", click "Printer and Other Hardware" and then click "Printer and Faxes".

On Windows 95/98/Me/NT4.0/2000, select "Settings" and then click

"Printers".

3

Right-click the "Olivetti d-Copia 150" icon in the printer dialog box and then click

"Properties".

Olivetti d-Copia 150

4

Click the "Port" tab ("Details" tab - on

Windows 95/98/Me) in the "Properties" dialog box, select

"FILE": in the "Print to the following port" list box, and click the

"OK".

5

Right-click the icon of the printer to be used and click

"Properties".

6

Click the "Port" tab ("Details" tab - on Windows 95/98/Me) in the

"Properties" window, select "LPT1" (or the currently used port), and click the "OK" button.

To use the Olivetti Personal MFP Series again, perform the same procedure but select the port to be used (for example, LPT1) in step 4.

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals