CONNECTING THE INTERFACE CABLE. Olivetti D-COPIA 150, d-Copia 120/150

Add to my manuals
78 Pages

advertisement

CONNECTING THE INTERFACE CABLE. Olivetti D-COPIA 150, d-Copia 120/150 | Manualzz

CONNECTING THE INTERFACE CABLE

This unit includes both USB and parallel interface connectors.

Interface cables for connecting the unit to your computer are not included with this unit. Please purchase the appropriate cable for your computer.

If you intend to use the unit as a scanner, it must be connected to your computer with a USB interface cable. The scanner function cannot be used if the unit is connected with a parallel cable.

• USB is available with a PC/AT compatible computer that was originally equipped with USB and had Windows 98, Windows Me,

Windows 2000 Professional, Windows XP Professional or Windows

XP Home Edition preinstalled.

• Do not connect the interface cable before installing the MFP driver.

The interface cable should be connected during installation of the

MFP driver. (p.21)

Connecting the USB interface cable

1

Obtain a shielded USB interface cable.

2

Insert the cable into the USB interface connector located on the rear of the unit.

4

3

Insert the other end of the cable into the interface connector of your computer, or the USB hub connected to your computer.

Connecting the parallel interface cable

1

Obtain an IEEE1284 shielded parallel interface cable.

2

Ensure that your computer and unit are turned off.

3

Insert the cable into the parallel interface connector located on the rear of the unit, and fasten with clasps.

4

Insert the other end of the cable into the interface connector of your computer.

45

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals