SET THE COPY QUANTITY. Olivetti D-COPIA 150, d-Copia 120/150

Add to my manuals
78 Pages

advertisement

SET THE COPY QUANTITY. Olivetti D-COPIA 150, d-Copia 120/150 | Manualzz

SET THE COPY QUANTITY

Set the number of copies using the two copy quantity ( , ) keys when copying from the original table or from the SPF if installed.

• Press the clear ( ) key to clear an entry if a mistake is made.

A single copy can be made with the initial setting, i.e., when "0" is displayed.

• Press the right copy quantity key to set the unit digit from 0 to 9. This key will not change the tens digit.

• Press the left copy quantity key to set the tens digit from 1 to 9.

EXPOSURE ADJUSTMENT/PHOTO COPYING

Exposure adjustment

Copy density adjustment is not required for most originals in the automatic exposure mode. To adjust the copy density manually or to copy photographs, the exposure level can be adjusted in five steps manually.

The copy resolution used for AUTO and manual ( changed. (p.53)

) mode can be

5

1

Press the exposure mode selector key to select the manual ( ) mode or photo

( ) mode.

2

Use the light ( ) and dark ( ) keys to adjust the exposure level. If exposure level

2 is selected, the two left-handmost indicators for that level will light up simultaneously. Also, if level 4 is selected, the two right-handmost indicators for that level will light up simultaneously.

49

50

Automatic exposure adjustment

This automatic exposure level will remain in effect until you change it again by this procedure.

The automatic exposure level can be adjusted to suit your copying needs. This level is set for copying from the original table and copying from the SPF respectively.

1

When adjusting the automatic exposure level for copying from the SPF, place an original in the original feeder tray and make sure that the SPF ( ) indicator lights up. When adjusting the level for copying from the original table, make sure that no original is left in the original feeder tray.

2

Press the exposure mode selector key to select the photo ( ) mode.

3

Press and hold down the exposure mode selector key for approximately 5 seconds.

The photo ( ) indicator will go out and the AUTO indicator will begin to blink. One or two exposure indicators corresponding to the automatic exposure level which has been selected will light up.

4

Press the light ( ) or dark ( ) key to lighten or darken the automatic exposure level as desired. If exposure level 2 is selected, the two left-handmost indicators for that level will light up simultaneously.

Also, if level 4 is selected, the two righthandmost indicators for that level will light up simultaneously.

5

Press the exposure selector key. The AUTO indicator will stop blinking and light up steadily.

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals