TD CARTRIDGE REPLACEMENT. Olivetti D-COPIA 150, d-Copia 120/150

Add to my manuals
78 Pages

advertisement

TD CARTRIDGE REPLACEMENT. Olivetti D-COPIA 150, d-Copia 120/150 | Manualzz

7

MAINTENANCE

This chapter describes how to replace the TD cartridge and drum cartridge.

Be sure to use only genuine Olivetti parts and supplies.

TD CARTRIDGE REPLACEMENT

The TD cartridge replacement required ( ) indicator will light up when toner is needed. For more information on purchasing the TD cartridge, see "ABOUT

SUPPLIES AND INTERFACE CABLES" (p.68). If copying is continued while the indicator is lit, copies will gradually become lighter until the unit stops and the indicator begins blinking. Replace the old TD cartridge by following the procedure below.

• After the unit stops, it may be possible to make a few more copies by taking the TD cartridge out of the unit, shaking it horizontally, then reinstalling it. If copying is not possible after this operation, replace the

TD cartridge.

• During long copy run of a dark original, the start ( ) indicator may blink, the indicator light up, and the unit stop, even though toner is left.

The unit will feed toner up to 2 minutes and then the start ( ) indicator will light up. Press the start ( ) key to restart copying.

1

Open the side cover and front cover, in that order.

To open the side cover and front cover, see "INSTALLING THE TD

CARTRIDGE" (p.10).

2

Gently pull the TD cartridge out while pressing the lock release button.

Lock release button

7

In order to help preserve the global environment, we recycle used TD cartridges. Please read "COPIER TONER CARTRIDGE RECYCLING", which is enclosed in the new toner cartridge package.

3

Install a new TD cartridge. To install the new cartridge, see

"INSTALLING THE TD CARTRIDGE" (p.10).

55

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals