STATUS INDICATORS. Olivetti D-COPIA 150, d-Copia 120/150

Add to my manuals
78 Pages

advertisement

STATUS INDICATORS. Olivetti D-COPIA 150, d-Copia 120/150 | Manualzz

60

STATUS INDICATORS

When the following indicators light up or blink on the operation panel or the following alphanumeric codes appear in the display, solve the problem immediately referring to both the table below and the relevant page.

Be sure to use only genuine OLIVETTI parts and supplies.

Indication

Steadily lit

Cause and remedy

Replacement of drum cartridge will be needed soon. Prepare a new cartridge.

Drum replacement required indicator

TD cartridge replacement required indicator

Misfeed indicator

Blinking

Steadily lit

Drum cartridge must be replaced. Replace it with a new one.

Replacement of TD cartridge will be needed soon. Prepare a new cartridge.

Blinking

Blinking

TD cartridge must be replaced. Replace it with a new one.

A misfeed has occurred. Remove the misfed paper referring to the description of "MISFEED

REMOVAL".

SPF misfeed indicator

Power save indicator is steadily lit.

Blinking

An original misfeed has occurred in the SPF.

Remove the misfed originals referring to the description of "D: Misfeed in the SPF".

The unit is in the preheat mode. Press any key to cancel the preheat mode.

The unit is in the auto power shut-off mode.

Press the start ( ) key to cancel the auto power shut-off mode.

Page

68

56

68

55

61

64

52

52

The paper tray indicator is blinking.

The paper tray is not installed properly. Push the tray into the unit securely.

"CH" is blinking in the display.

The TD cartridge is not installed. Check if the cartridge is installed.

"CH" is steadily lit in the display.

Side cover is open. Close the side cover securely by pressing the round projections near the side cover open button.

"P" is blinking in the display.

The paper tray is empty, or single bypass has been selected in the printer function.

Load paper.

A misfeed has occurred in the paper tray or single bypass. Remove the misfed paper.

55

15, 17

61

A letter and a number appear alternately.

The scan head locking switch is locked. Unlock the scan head locking switch and turn the power switch off/on.

9

A letter and a number appear alternately.

The unit will not function. Turn the power switch off and then switch it on, and if there is again an error, remove the power cord from the outlet, and contact your authorized service representative.

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals