MOVING AND STORING THE UNIT. Olivetti D-COPIA 150, d-Copia 120/150

Add to my manuals
78 Pages

advertisement

MOVING AND STORING THE UNIT. Olivetti D-COPIA 150, d-Copia 120/150 | Manualzz

MOVING AND STORING THE UNIT

Moving instructions

When moving the unit, follow the procedure below.

When moving this unit, be sure to remove the TD cartridge in advance.

1

Turn the power switch off and remove the power cord from the outlet.

2

Open the side cover and front cover, in that order. Remove the

TD cartridge and close the front cover and side cover, in that order.

To open and close the side cover and front cover, and to remove the TD cartridge, see "TD CARTRIDGE REPLACEMENT" (p.55).

3

Raise the handle of the paper tray and pull the paper tray out until it stops.

4

Push the center of the pressure plate down until it locks in place and lock the plate using the pressure plate lock which has been stored in the front of the paper tray.

5

Push the paper tray back into the unit.

6

Lock the scan head locking switch (p.9).

When shipping the unit, the scan head locking switch must be locked to prevent shipping damage.

7

Close the paper output tray extension, and attach the packing materials and tape which were removed during installation of the unit. See "PREPARING THE UNIT FOR INSTALLATION"

(p.8).

8

Pack the unit into the carton. See "CHECKING PACKED

COMPONENTS AND ACCESSORIES" (p.8).

Proper storage

Store the supplies in a location that is:

• clean and dry,

• at a stable temperature,

• not exposed to direct sunlight

Store paper in the wrapper and lying flat.

• Paper stored out of the wrapper or in packages standing on end may curl or get damp, resulting in paper misfeeds.

9

69

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals