- Sports & recreation
- Camping, tourism & outdoor
- Above ground pools
- Above ground pool accessories
- Zodiac
- pH perfect
- User manual
3.2 Rule for injecting pH Perfect. Zodiac pH perfect
Add to My manuals20 Pages
Zodiac pH Perfect is a device designed to maintain your pool's pH balance, ensuring optimal water chemistry for your skin, eyes, and hair. It also keeps your sanitizer working efficiently. The pH level is detected by a sensor, and corrective solution is injected into the pool water as needed, keeping it safe and healthy.
advertisement
• Once the calibration is complete, your pH Perfect is ready to regulate your pool automatically.
• If your water chemistry is badly out of balance please bring your pool pH within balance before activating the pH Perfect.
The pH Perfect peristaltic pump is self-starting. However, it is possible to operate it manually by keeping the ” p “ Navigation button pressed.
The peristaltic pump will then inject corrective solution as long as the button is pressed.
3.2 Rule for injecting pH Perfect
Proportional cyclic dosing - exclusive to Zodiac
• To reach the set point in the best possible conditions (the quickest, but with the least possible corrective solution), your pH Perfect automatically detects the difference of the pH value measured in the pool compared with the desired set point (default value = 7.4 pH).
• This proportional injection is cyclic and the cycle time is 10 minutes. What will change in dosing is the different times of injection and pause. The proportions are adjusted automatically and the different dosages are distributed in steps of 0.15 pH.
E.g.: For 4 cycles with a set point of 7.4 pH and acid regulation (standard alkalinity levels)
:
pH
≥
7,55
: 20% injection (2 minutes) & 80% pause (8 minutes)
pH
≥
7,70
: 50% injection (5 minutes) & 50% pause (5 minutes)
pH
≥
7,85
: 75% injection (7 minutes 30 seconds) & 25% pause (2 minutes 30 seconds)
pH
<
7,90
: 100% injection (10 minutes, continuous)
8
advertisement
Related manuals
advertisement
Table of contents
- 3 1.1 Identification of parts
- 4 1.2 The Control Panel
- 5 2.2 Technical details
- 6 2.3 Installation Diagram
- 7 2.4 Installation of the Sensor POD
- 9 3.1 Calibration procedure
- 10 3.2 Rule for injecting pH Perfect
- 11 3.3 Adjusting the dosage depending on alkalinity
- 12 4.1 “Settings” menu - Default parameters
- 12 4.2 Language
- 12 4.3 Set point
- 13 4.4 Type of dosage
- 13 4.5 Alkalinity level
- 13 4.6 “OFA” over-feed protection
- 14 4.7 Detection that filtration is in progress
- 15 4.8 Resetting the appliance
- 15 5.1 Changing the peristaltic pump tube
- 15 5.2 Winterising the pH Perfect