advertisement
4. Adjustments: “Settings” menu
4.1 “Settings” menu - Default parameters
The pH Perfect is factory preset with the following settings (suitable for most cases): a. Set point:
pH = 7.4
b. Dosage = acid (injection when the pH is higher than the set point) c. Alkalinity level =
standard
d. “OFA” over-feed protection:
4 hours
e. Calibration f. Detection that filtration is in progress:
enabled
A
B
To access the “Settings” menu, the appliance must be ON.
Simultaneously press the “CAL/Enter” and “SET/Esc” buttons for about 5 seconds until the LCD screen displays “Settings” (A).
This “settings” menu gives access to the following adjustments:
Language
Set point
Type of dosage
Alkalinity level
Time before triggering the “OFA” over-feed protection
Type of calibration
Detection that filtration is in progress
To exit the “Settings” menu, press the “SET/Esc” button and select “Yes” or “No”, using the “ p
” and “ q
” navigation buttons to save the new settings or not. Accept the choice by pressing the
“CAL/Enter” button (B).
4.2 Language
C
You can choose between 6 languages for the LCD display:
French, English, German, Spanish, Italian and Dutch.
To change language when in the “Settings” menu, enable the option list by pressing the “CAL/Enter” button (a small arrow appears on the right of the screen and the language message flashes).
Then select the language using the “ p ” and “ q ” navigation buttons.
Accept the choice by pressing the “CAL/Enter” button.
D
4.3 Set point
The default set point on the pH Perfect is 7.4 pH (D)To change it when in the “Settings” menu, enable the option list by pressing the “CAL/Enter” button (the pH value fl ashes). Then select the value chosen using the
“ p ” and “ q ” navigation buttons. The adjustment is made in increments of 10 mV. Accept the choice by pressing the “CAL/Enter” button.
It is also possible to directly access the set point by holding down the “SET/Esc” button
(keep pressing while changing the setting using the “
p
” and “
q
” navigation buttons).
10
advertisement