Unit Nameplate . Trane CVHE-SVX02M-EN, CVHG, CVHF, CVHE
advertisement
8
Unit Nameplate
The unit nameplate is located on the left side of the control panel. A typical unit nameplate is illustrated in the following figure and contains the following information:
• Unit model and size descriptor
• Unit electrical requirements
• Correct operating charge and refrigerant type
• Unit test pressures and maximum operating pressures
• Unit literature specific chiller identity. Always provide this serial number when calling for service or during parts identification.
e M od Nu be the unit as built for service purposes. It identifies the selections of variable unit features required when ordering replacements parts or requesting service.
separate number found on the starter.
models are defined and built using the Product
Definition and Selection (PDS) system. This system describes the product offerings using a product coding block which is made up of feature categories and codes that identify all characteristics of a unit.
Figure 1. Typical unit nameplate
CVHE-SVX02M-EN
advertisement
