advertisement
680 SERIES
10.5 Filtration Modes
During the filtration/heating cycle the Jets pump 1 low speed will activate.
To set a time for the first filtration/heating cycle, simply turn power on to the spa two minutes prior to the desired time. Example: If you desire your first filtration/heating cycle to begin at 10:00 AM turn off power to the spa and turn it back on again at 9:58 AM. You can also press the Warmer,
Cooler and Jets Pump 1 buttons simultaneously for 2 seconds to restart the spa.
Note:
Start time is approximate and may vary slightly from day to day.
Standard Filtration/Heating Modes (F1-F3)
F1
4 hours of filtration/heating per day (one 2-hour cycle every
12 hours).
F2
6 hours of filtration/heating per day (one 2-hour cycle every
8 hours).
F3
8 hours of filtration/heating per day (one 2-hour cycle every
6 hours).
Economy Filtration/Heating Modes (F4-F6)
F4
4 hours of filtration/heating per day (one 2-hour cycle every
12 hours).
F5
6 hours of filtration/heating per day (one 2-hour cycle every
8 hours).
F6
8 hours of filtration/heating per day (one 2-hour cycle every
6 hours).
Lock Modes (L1-L3)
(When in a lock mode the display will flash between the temperature and the Lock mode number)
L1
Lock Out (disables all spa functions to permit filter cleaning).
Note:
The spa should not be left in this lock mode for an extended period of time. Especially in colder climate or when freezing conditions exist.
L2
Lock Mode (disables the jets and light buttons to prevent unauthorized use of spa). Filtration/heating cycle will continue to operate as programmed in this mode. The temperature display flashes when this function is enable. Example: the “F3” filtration/ heating cycle was enabled prior to choosing lock mode. The spa continues to perform the “F3” cycle until lock mode is canceled, allowing another cycle to be selected.
Page 31
advertisement