advertisement
680 SERIES
L3*
Lock Mode (disables the temperature up and down buttons to prevent unauthorized temperature adjustments). Filtration/heating cycle will continue to operate as programmed in this mode. The jets and lights buttons will still continue to operate as normal. The temperature display flashes when this function is enabled. *Due to a difference in software this feature is not available for all models.
Note:
To exit a Lock Mode you will need to re-enter the filtration/heating modes and select a cycle from F1-F6.
10.6 Programming the CLEARRAY (Ultraviolet) Water Purification
System
A.
Programming the
CLEAR
RAY System (U) or Corona Discharge
Ozone (O3)
Press and hold the
Jets pump 1
( ) and
Cooler
( ) button
at the same time
for 3 seconds to enter the sanitizing system program. The screen will display one of the two menus below:
CLEAR
RAY
menu
Press
O3 menu
Press or or
1. If the LED screen is displaying “U” then pressing the Jets pump
1 will change the sanitizing system from “U” to “O3” and exit the programming menu. If the LED screen is displaying “O3” then pressing the Jets pump 1 will change the sanitizing system from “O3” to “U” and exit the programming menu.
Note:
For the O3 option the “=” disables the duration countdown timer.
2. If you do not wish to change the option do not press any buttons and after 10 seconds the display will return to the main menu.
Note:
If the CLEAR
RAY
System has been selected, when the time allotted has expired (365 days) the display screen will flash between the water temperature and “blb.” At this time the UV bulb must be replaced, the quartz tube must be cleaned and the duration countdown timer needs to be reset.
Page 32
680 SERIES
B.
Resetting the duration countdown timer (
CLEAR
RAY System only)
Once the duration countdown timer for the CLEAR
RAY
System has reached zero, you will need to reset it, replace the UV bulb and clean the quartz tube.
To reset the duration countdown timer:
Press Press
1
1. Press and hold the
Jets pump 1
( ) and
Cooler
( ) button
at the same time
for 3 seconds.
2. Press the
Warmer
( ) button until the display shows “0.”
3. If the timer has reached “0,” pressing the
Jets pump 1
( ) button will reset it.
If the timer is not at “0” pressing the Jets pump 1 button will not reset it.
Note:
If the spa power is interrupted, the duration countdown timer is not affected. The number of days remaining is stored in the memory and will continue to countdown once power is regained.
4. If the duration countdown timer is not at “0” and you need to reset it: a. Press and hold the Jets pump 1 and Cooler buttons at the same time for 3 seconds.
b. Press the Warmer button to scroll to “U.” c. Press the Jets pump 1 button to switch from “U” to “O3.” d. Press and hold the Jets pump 1 and Cooler buttons at the same time for 3 seconds.
e. Press the Warmer button to scroll to “O3.” f. Press the Jets pump 1 button to switch from “O3” to “U.” The timer has been reset to 365 days.
Page 33
advertisement