advertisement
680 SERIES
!
CAUTION! READ THIS BEFORE DRAINING:
To prevent damage to the spa’s components, turn off power to the spa at the circuit breaker before draining it. Do not turn the power back on until your spa has been refilled. There are certain precautions to keep in mind when draining your spa. If it is extremely cold, and the spa is outdoors, freezing could occur in the lines or the equipment (see “WINTERIZING”, page
38). On the other hand, if it is hot outdoors, do not leave the spa’s surface exposed to direct sunlight.
To drain your spa, perform the following steps (actual drain may vary from one shown). Turn off power to spa at breaker.
1. Locate and remove the synthetic cabinet door screws and door. The door is located directly below the control panel and is easily identified by it’s vertical cooling slots.
2. Locate drain hose line attached to 2 x 4 wood slat
(Figure A) with tie wraps.
3. Cut tie wraps and pull drain hose from equipment area (Figure B).
4. Hold drain hose above water line, then unthread drain cap (1) from hose using a counterclockwise rotation (Figure B). Place hose on ground making sure to direct water away from spa. If equipped, turn valve (2) counterclockwise to open the valve
1
Figure A
2
Figure B
(Figure C).
5. After spa has completely drained, reinstall drain cap on drain valve finger tight! DO NOT
OVERTIGHTEN! If equipped turn valve (2) clockwise to close the valve.
Figure C
Drain location and appearance may vary.
6. Place drain hose back inside the spa equipment bay.
7. Reinstall synthetic cabinet door and screws.
8. After refilling spa, turn on power and follow the “Spa Fill Up
Procedure” (page 18).
11.3 Pillow Care (All Models Except Denali)
Remove and clean the headrest pillows as needed with soapy water using a cloth or soft-bristle brush. To maintain water resistance and luster, apply a quality vinyl conditioner once a month. Always remove the pillows when adding chemical shock treatment to the spa water. The pillows can be returned to the spa when the sanitizer reading is stable as recommended on the inside cover of the manual.
Page 36
advertisement