- Home
- Domestic appliances
- Large home appliances
- Cooker hoods
- ELICA
- ERS630S1
- Installation instructions
advertisement
Downdraft Use
Use the high suction speed in cases of concentrated kitchen vapours.
It is recommended that the cooker hood suction is switched on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately after terminating cooking.
The control panel consists of a backlit rotating disk.
D A
C
E
B
Vent System Care
Surface of Downdraft Vent
To avoid damaging the finish, clean downdraft vent with soap and water. Do not use scouring powder or abrasive solutions.
Exterior Surfaces:
To avoid damage to the exterior surface, do not use steel wool or soap-filled scouring pads.
Always wipe dry to avoid water marks.
•
Liquid detergent soap and water, or all-purpose cleanser
Wipe with damp soft cloth or nonabrasive sponge, then rinse with clean water and wipe dry.
To Clean:
1.
Remove the aspiration plate and the filter(s) and clean them in a dishwasher or in a hot detergent solution. The downdraft vent will not operate when the filters are not in place.
2.
Dry the clean filter(s) and reinstall, making sure that they lock into
place.
To Replace Filters:
1.
Place filters into the retractable section of the downdraft vent.
2.
Place fingertips into the embossment at the top of the filters and push down and back to allow the top tabs to snap in place.
B
C
A
To raise the downdraft vent system:
Press on the disk (E) aprox 2 seconds to raise the downdraft vent system.
Press on the disk (E) aprox 2 seconds to hide the downdraft vent system.
NOTE:
If you press the disk to hide the downdraft system while it is working, the appliance will automatically turn off.
To select the available suction speeds:
Turn the disk (E) clockwise to turn on and increase the suction speed and counter-clockwise to decrease it, and to turn off the hood.
The crown lights to indicate the selected suction speed:
A lit
speed 1 (minimum).
A + B lit
speed 2 (medium).
A + B + C lit
Speed 3 (maximum).
A + B + C + D lit
Speed 4 (intensive), lasting for 5 minutes, then the hood is placed automatically at speed 2.
A off:
Suction motor off.
A + B + C + D lit in flashing mode
The light crown will flash after 40 hrs. of work. This indicates that the grease filters must be removed and cleaned.
This function must be reset by pressing the button for 5 seconds.
A. Aspiration plate
B. Grease filter handle
B. Grease filters
NOTE:
Downdraft vent will not operate if the aspiration plate are not in its proper position. If the aspiration plates’ top tabs are not locked behind the top flange, the vent may retract but not raise back up. If retractable downdraft vent does not operate after clean aspiration plate have been installed:
Push the aspiration plate in as far as it will go. When the plate is removed, the microswitch behind the filter is inactivated. This feature will not allow the vent system to operate until the aspiration plate is properly installed.
13
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 3 Important safety Notice
- 4 Electrical & Installation requirements
- 4 Before installing the hood
- 5 List of Materials
- 5 Parts supplied
- 5 Parts not supplied
- 5 Product Dimensions
- 6 Countertop Cutout Dimensions
- 6 Venting Requirements
- 7 Installation Instructions
- 8 Determine which vent directioin is best for your installation
- 9 Rear mounting (reversible mode)
- 10 Complete Installation
- 11 Control Installation
- 11 Electrical connection
- 13 Downdraft use
- 13 Vent system care
- 14 Troubleshooting
- 15 Warranty
- 17 Avis de sécurité important
- 18 Exigences électriques et d’installation
- 19 Outils et piéces
- 19 Pièces fournies
- 19 Pièces non fournies
- 19 Dimensions du produit
- 20 Dimensions des ouvertures à découper
- 20 Exigences concernant l’évacuation
- 21 Instructions d’installation
- 22 Déterminer la meilleure orientation de l’évacuation pour l’installation
- 23 Montage arriére (mode réversible)
- 24 Achever l’installation
- 25 Raccordement électrique
- 27 Utilisation du système d’extraction par le bas
- 27 Entretien du système d’évacuation
- 28 Dépannage
- 31 Aviso de seguridad importante
- 32 Requisitos eléctricos y de instalación
- 33 Lista de Materiales
- 33 Partes suministradas
- 33 Partes necesarias
- 33 Dimensiones del producto
- 34 Dimensiones de corte de la cubierta de cocina
- 34 Requisitos de ventilación
- 38 Complete la Instalación
- 39 Instalación del control
- 39 Conexión eléctrica
- 41 Uso de la campana
- 41 Cuidado de la campana
- 42 Solución de problemas
- 43 Garantía