Product Features. ProCom Heating MN200EPC, MN200EHBC
Advertisement
Advertisement
SAFETY INFORMATION
WARNING: Do not use any accessory not approved for use with this heater.
WARNING: Any change to this heater or its controls can be dangerous.
WARNING
Modeles MN200EBC MN200EHBC
MN300EBC MN300EHBC are equipped for Natural Gas. Field conversion is not permitted.
Due to high temperatures, heater should be kept out of traffic and away from furniture and draperies.
Front surface of heater becomes very hot when running heater.
Keep children and adults away from hot surface to avoid burns or clothing ignition. Heater will remain hot for a time after shut down. Allow surface to cool before touching.
Do not place clothing or other flammable material on or near the appliance. Never place any objects on the heater.
C are fu lly s up e rv ise yo un g children when they are in the same room with heater.
Make sure grill guard is in place before running the heater.
Keep the appliance area clear and free from combustible materials, gasoline, and other
flammable vapors and liquids.
1. This appliance is only for use
with the type of gas indicated
on the rating plate. This
appliance is not convertible for
use with other gases.\
2. If you smell gas l Shut off gas supply.
l Do not try to light any appliance.
l Do not touch any electrical
switch, do not use any phone in your building.
l Immediately call your gas supplier from a neighbor’s phone.
F o l l o w t h e g a s s u p p l i e r ’ s instructions.
l If you cannot reach your gas supplier, call the fire department.
3. This heater shall not be in stalled in a bedroom or bathroom.
4. This heater needs fresh, outside air ventilation to run properly. This heater has an Oxygen Depletion
Sensor (ODS) safety shutoff system.The ODS shuts down the
heater if not enough fresh air is available. See Fresh Air for
Combustion and Ventilation pages 5 and 6.
5. Keep all air openings in front and bottom of heater clear and free of debris. This will insure enough air for proper combustion.
6. If heater shuts off. Do not relight until you provide fresh, outside air. If heater keeps shutting off, have it serviced.
7. Do not operate l W here flammable liquids or vapors are used or stored l Under dusty conditions
8. Before using furniture polish, wax, carpet cleaner, or similar p ro d u c ts, tu rn h eater o ff.If
heated, the vapors from these products may create a white powder residue within burner box or on adjacent walls or furniture.
9. Do not use heater if any part has been under water. Immediately call a qualified service technician to inspect the room heater and to replace any part of the control system and any gas control which has been under water.
10.Turn off and unplug heater and let cool before servicing. Only a qualified service person should service and repair heater.
11.Operating heater above elevations of 4,500 feet could cause pilot outage.
PRODUCT FEATURES
(See Figure 1,page 4)
SAFETY PILOT
This heater has a pilot with an
Oxygen Depletion Senso r(ODS) safety shutoff system.
The ODS/pilot shuts off the heater if there is not enough fresh air.
AUTOMATIC IGNITION
SYSTEM
This heater is equipped with an automatic control system.
This system requires no matches, or batteries to light heater.
TOUCH PAD
THERMOSTATIC HEAT
CONTROL
This heater has a control module with a thermostat sensing bulb. set temperrature with touch pad. This results in the greatest heater comfort and may result in lower gas bills.
MANUL OVERRIDE
CONTROL SYSTEM
(MN200EHBC, MN300EHBC)
There are two control systems, electric and manual overide.If no electric power is available,you can operate heater by manual overide.
LOCAL CODES
This heater is designed for vent-free operation. Some state and local codes prohibit the use of vent-free heater.
3

Download
Advertisement