Setting the jumper terminals. Asus DRW-0804P-D

Add to My manuals
46 Pages

advertisement

Setting the jumper terminals. Asus DRW-0804P-D | Manualzz

Setting the jumper terminals

Set the jumpers to configure the device to either master or slave mode before installing it into your computer chassis. The different modes are discussed below. Select your desired mode by placing the jumper cap over the pins.

Put the jumper caps properly over the pins to avoid damage to the drive.

Jumper terminals

14

Master Mode

Cover the two pins labeled MA (see illustration) to set the drive as a secondary master drive.

Select this mode if your computer supports four

IDE devices. The computer hard drive is set as

Primary Master.

RESERVED

M

A

PIN 1

Slave Mode

Cover the two pins labeled SL (see illustration) to set the drive as a slave device if your computer supports only two IDE devices. If your computer supports four IDE devices, this mode sets your drive as either Primary or Secondary

Slave.

RESERVED PIN 1

S

L

Cable Select Mode

Cover the two pins labeled CS (see illustration) if your computer supports a Cable Select

(CSEL) signal. You need an exclusive interface cable for this mode. Refer to your computer manual for details.

RESERVED

C

S

PIN 1

ASUS DRW-0804P DVD ± R/RW drive

advertisement

Related manuals