Secvest Info and Display Module. Abus Eytron HDVR, Eytron NVR, Eytron JPEG2000, Terxon MX, Eytron MJPEG, Secvest 2WAY, Privest, Eytron VMS, Eyseo TVCC40000, Terxon SX

Secvest Info and Display Module

Wireless info module Wireless display module

Secvest switching power supply

Ensures the Secvest 2WAY components are supplied with power.

• Voltage: 12 VDC

• Amperage: 1500 mA

• Euro plug-in connector

• Suitable for info module, keypad, indoor siren, universal module

Install the wireless info module on an extra entry-way or in different rooms in the house. It tells you all of the processes and statuses of the

Secvest 2WAY via an LED display and various signals and warning tones. The most important system information, such as the statuses of the individual partitions, etc. can be seen at a glance thanks to the eight LEDs. The internal piezo siren also provides a loud (up to

110 dB) internal alarm in an alarm situation. The wireless info module can be located up to 30 meters away from the panel, depending on the structural conditions.

• Input delay is running

• Door gong

• Panel successfully armed

• Read-in signal received

• Exit setup mode

Technical data:

•

•

•

•

•

•

•

•

Environmental class II

Safety class: 2 EN50131-1, -3

Protection class: IP 54

Operating temperature: -10°C to

+55°C

Power supply: 9-14V DC, 12 VDC nominal

Frequency: 868.6625 Mhz

Eight different LED displays

Piezo siren up to 110 dB

• Weight: 200 g

• Dimensions (WxHxD):

124x124x40.7 mm

You can see the following system statuses on the 8 LEDs of the info module:

• Voltage display

• Reception of a valid signal

• Status of the partition to which the info module is assigned (internally armed / armed / disarmed)

• Information available after reset

• Open zones

• The input or output delay time is running

• An alarm has been triggered

Optional accessories:

Secvest switching power supply

(FU3822), surface mount power supply (TV8371)

Alarm tones:

• Fault: The system cannot be armed

• A zone was opened/closed again during the output delay

Via the wireless display module, you get a quick overview of the status of the Secvest detectors in the house. Here, you can see at a glance whether a detector or a window is open or closed. The module has a convenient status display for the FTS 96 E wireless window lock and the Secvest wireless opening detectors - even in stand-alone mode (without the alarm panel).

However, if the window locks are operated in combination with a

Secvest 2WAY , the module is an important supplement - window lock and wireless opening detectors can be read-into the display module and the alarm panel at the same time.

• 16 display channels, individually programmable

• Display module has own status display

• Compatible with the FTS 96 E wireless window lock and Secvest wireless opening detectors

• Power supply: 12 V

• Incl. pluggable power supply

• Dimensions (WxHxD):

135x220x45 mm

• Available as of February 2009

Article number FU3822

Surface mount power supply

An inconspicuous power supply is possible with the surface mount power supply.

• Mini-power supply for the info module, keypad, siren and universal module

• For installing in 55 mm surface

• mount outlet sockets

Stabilized power supply 230 VAC /

12 VDC (1000 mA)

Article number FU8200 Article number FU8403 Article number TV8371