Terxon SX Alarm Panel. Abus Eytron HDVR, Eytron NVR, Eytron JPEG2000, Terxon MX, Eytron MJPEG, Secvest 2WAY, Privest, Eytron VMS, Eyseo TVCC40000, Terxon SX

ABUS Security-Center

Terxon SX Alarm Panel

Arming made to order

Depending on the situation and what your wants or needs are, you have three convenient ways to arm/disarm the Terxon.

Terxon SX alarm panel

One option is to activate the system via the LCD keypad. These keypads can be installed at several entrances and in protected outside areas (IP54), so that it remains possible to access the house in several different ways.

The add-on keypad can also be used in multi-story buildings.

Another easy and secure method is to arm/disarm using the key-switch, which can also be installed in the outside area.

The quickest and easiest way to arm or disarm the Terxon is to use the proximity chip key.

Simply hold the key in front of the keypad (no need to make contact).

Terxon SX + Terxon 2WAY module = bi-directional wireless for wired alarms

With the new Terxon 2WAY module, you can integrate all of the bidirectional wireless components of the Secvest 2WAY into the Terxon. This gives you countless new possibilities. You can arm and disarm the Terxon

SX at the push of a button via the bi-directional wireless remote control of the Secvest 2WAY, for example. Four integrated LEDs always show you the current status of the system.

The following components of the Secvest 2WAY can be integrated via the

Terxon 2WAY module: Wireless remote control, wireless keypad, wireless key-switch, Secvest key, wireless outside and inside sounders (seepage

140).

From private homes to commercial properties: The Terxon SX from

ABUS Security-Center provides the right level of security. Eight freely programmable zones are at your disposal for installing wired detectors. The ninth zone is preconfigured as an tamper zone.

Programming and operating are conveniently done via the remote

LCD keypad (in delivery kit). In the event of an alarm, a switching output for the sounder and one for the flashing light can be activated.

Nine additional transistor outputs are available on the Terxon SX board. You can use these to control other external components (e.g.: a speech dialer). You have also several options for operating the

Terxon SX: Via a PIN code and proximity chip key on the keypad, or by simply turning the key in the key-switch. In combination with the Terxon 2WAY module, you can even integrate wireless detectors and control components.

• Normally closed (NC) or double end of line (DEOL)

• 3 transistor outputs max. 500 mA, 8 transistor outputs max. 50 mA

• Integrated power supply unit

230VAC/12VDC (1A)

• Optional pluggable relay module

•

(AZ4140)

Incl. keypad with LCD display, buzzer and 11 languages to choose from

• Intended for backup battery

12 V/7 Ah (not included in delivery kit)

• User code and installer code freely

•

• selectable

Up to 16 different users

4-wire BUS-connection for up

• to 4 LCD keypads

250x event memory with time

• stamp

Certifications: NCP, VSÖ, Incert,

•

F&P

Dimensions panel

(WxHxD): 235x235x85 mm, keypad

(WxHxD): 113x90x23 mm

• Optional accessories:

• VdS battery 7 Ah

Article number AZ4000