Terxon 2WAY Module. Abus Eytron HDVR, Eytron NVR, Eytron JPEG2000, Terxon MX, Eytron MJPEG, Secvest 2WAY, Privest, Eytron VMS, Eyseo TVCC40000, Terxon SX

ABUS Security-Center

Terxon 2WAY module

Terxon 2WAY Module

The Terxon 2WAY module is a bi-directional wireless expansion module for wired alarm systems.

It allows the combination of wired alarm panels from any manufacturer with bi-directional

2WAY system components

(sounders and arming devices of the Secvest 2WAY).

Because the Terxon 2WAY module communicates via alarm inputs and switching outputs, it can be integrated not just into the Terxon series, but also in nearly every wired alarm system.

The following components of the

Secvest 2WAY can be integrated via the Terxon 2WAY module: Wireless remote control, wireless keypad, wireless key-switch, the Secvest key, wireless outside and inside sounders.

• Integration of all of the bidirectional Secvest 2WAY wireless components into wired alarm systems

• 6 switching outputs, for transmitting commands from the components

• 10 inputs, for the forwarding of different status information of the alarm panel

• Monitored against tamper

• Frequency: 868.6625 MHz

• Duplex antenna technology

• Bandwidth: 20 kHz

• Display: 10 LEDs

• Range outdoors approx. 200 m

• Range indoors: 30 m, depending on

• the construction materials

Operating voltage: 12 VDC

• Amperage: max. 55 mA

• Compatible with almost all wired alarm systems

• Weight: 342 g

• Dimensions (WxHxD):

128x183x35 mm

Article number AZ4290

Integrate bidirectional wireless components into your wired alarm system

Do you want to integrate a wireless outside sounder into your Terxon system? Or perhaps combine a bi-directional remote control with your existing alarm system? The Terxon 2WAY module is the right solution for this. With it, you can:

1. Receive commands from bi-directional Secvest 2WAY components wireless and pass them to the Terxon by wire.

Accessories for Terxon 2WAY module

Send commands from other components to the Terxon

You have six switching outputs at your disposal on the board of the Terxon 2WAY wireless module. They are connected to the corresponding alarm inputs of the Terxon alarm panel.

2. Receive status information from the panel and send it wireless to the bi-directional components of the Secvest 2WAY

Terxon 2WAY module

6 outputs

10 inputs

Wired panel (e.g. Terxon)

Send information from the Terxon to the wireless components.

You can make the following setting via the programming menu of the Terxon: As soon as something changes in the status of the alarm panel, the Terxon activates an output. This output is connected to one of the ten switching inputs of the Terxon

2WAY wireless module.

In this way, the 2WAY module receives all of the information about the current status of the system.

Uni-directional wireless components such as the wireless detectors are also integrated into the system via the wireless expansion modules.