Care and Cleaning. Ancona FREESTANDING RANGE GAS COOKTOP ELECTRIC OVEN

Add to my manuals
50 Pages

advertisement

Care and Cleaning. Ancona FREESTANDING RANGE GAS COOKTOP ELECTRIC OVEN | Manualzz

Care and Cleaning

ELECTRICAL SHOCK HAZARD

BURN HAZARD

To avoid possible burns use care when cleaning the appliance.

DO NOT attempt to clean the appliance whenever the oven or burner heads are still hot.

To avoid possible burns DO NOT attempt any of the following cleaning instructions before turning OFF ALL of the surface burners and allowing them to cool.

IMPORTANT: Always follow label instructions on cleaning products.

• Control Knobs

− For general cleaning, use hot, soapy water and a cloth.

− For more difficult soils and built-up grease, apply a liquid detergent directly onto the soil. Rinse with a damp cloth and dry.

DO NOT use steel wool or acidic cleaners on the knobs as they can scratch.

• Burner Grates

− Clean burner grates in the dishwasher and dry upon removal.

− Please note that the grates are equipped with rubber pads on the feet that come into contact with the range to avoid scratches. After cleaning it is important to verify that these rubber pads are still there. Should they come off, they can be reapplied using heat resistant adhesive.

− Grates should be positioned correctly over the burners as shown. (See Figure 34)

Figure 34

• Burner Caps

− To clean the burner caps, lift the burner cap off the burner head. Clean heavy soils with an absorbent cloth.

− Rinse with a clean, damp cloth and immediately thoroughly dry including the bottom and inside of the cap.

− Do not use harsh abrasive cleaners. They can scratch the cap.

DO NOT PUT BURNER UNITS IN THE DISHWASHER

• Burner Heads

− The holes in the burners of your appliance MUST be kept clean at all times for proper ignition and a complete, even flame. Remove any food from between the burner slots using a small nonabrasive brush like a toothbrush and afterwards wipe using a damp cloth.

− To remove deposits from the burner cavities, remove the cap and separate the two parts.

Clean the burner holes routinely with a small gauge wire or needle and especially after bad spillovers which could clog these holes.

− After cleaning, put the two parts back together and return them correctly to their position, making sure they are seated and level.

DO NOT PUT BURNER UNITS IN THE DISHWASHER

• Stainless Steel

− Clean stainless steel with hot, soapy water and a dishcloth. Rinse with clean water and a cloth.

− Do not use cleaners with high concentrations of chlorides or chlorines. Do not use harsh scrubbing cleaners. Only use kitchen cleaners that are especially made for cleaning stainless steel.

• Inside Oven

− This appliance does NOT have a self-cleaning feature.

DO NOT attempt to clean the appliance whenever the oven is still hot.

− Use an appropriate cleaning product designed specifically to clean the inside of ovens.

IMPORTANT: Always follow label instructions on cleaning products.

• Cleaning Interior Lower Grill Element

− To remove the element, support one side with your hand while removing the retainer with the other.

− When cleaning, make sure not to apply excessive force on the element as it is fragile.

− Reposition the element and secure the retainer back in place.

− DO NOT use the oven with the grill element hanging down – it must be repositioned after cleaning.

• Storage Drawer

− Make sure drawer is cool and empty before cleaning.

− Use a mild detergent.

• Oven Door Exterior

− Use a glass cleaner and a soft cloth or sponge.

− Apply glass cleaner to soft cloth or sponge, not directly on panel.

• Removing and Cleaning the Oven Door

For normal range use, it is not suggested to remove the oven door. However, if removal is necessary, make sure the oven is off and cool. The oven door is heavy. Follow these instructions.

− Open the door fully.

• Lift up and turn the small levers located on the two hinges.

• While holding the door on each side, close it approximately half way.

• While in this position release the door by pressing clamps ‘F’ (see illustration below) and pull the door towards you. (See Figure 35)

− To replace the door, perform the reverse of the above procedure.

• Changing the Interior Oven Light Bulb

ELECTRICAL SHOCK HAZARD

− Ensure that the appliance is switched off before replacing the lamp to avoid possible electric shock.

− Remove the glass cover by turning counter clockwise. (See Figure 36)

− Replace bulb with a high temperature bulb able to withstand 600 degrees and that meets the following criteria:

• 240V

• 25W

• Type: E-14

Figure 36

Figure 35

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals