• A typical air line layout is shown above. If an automatic in-line filter/ regulator is used, it will keep the tool in good condition, but should be regularly checked and topped up with oil. SAE 10 oil should be used, and the lubricator adjusted to approx 2 drops per minute.
BEFORE USE
WARNING: COMPRESSED AIR CAN BE DANGEROUS. ENSURE THAT YOU
ARE FAMILIAR WITH ALL PRECAUTIONS RELATING TO THE USE OF AIR
COMPRESSORS AND COMPRESSED AIR SUPPLY.
NOTE: Ensure the compressor is turned off.
1. If required, connect an in-line mini oiler to the tool.
• A mini oiler helps to prolong the life of the impact wrench.
Remove the oil fill screw from the side of the mini oiler and fill with Air-line Oil available from your CLARKE dealer. Replace the screw before using the wrench.
2. If a mini-oiler is not being used, run a few drops of oil through the tool before use. It can be entered through the inlet strainer or via the hose at the nearest connection to the air supply.
3. Connect a suitable hose as shown.
4. Connect the other end of the hose to the compressor.
5. Your impact wrench is now ready for use.
You can fit a whip hose with a quick fit coupling if required (available from your Clarke dealer.)
7
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
USING THE FORWARD/REVERSE BUTTON
WARNING: WAIT UNTIL THE ANVIL HAS STOPPED ROTATING BEFORE
OPERATING THE FORWARD/REVERSE BUTTON.
Forward/Reverse rotation is selected by pushing the Forward/Reverse control forward or backward as required.
1. For normal tightening, the wrench should be operated in the forward direction.
2. For loosening, the wrench should be operated in the reverse direction.
FITTING THE IMPACT SOCKET
WARNING: NEVER USE STANDARD SOCKETS. THESE MAY SHATTER WITH
SERIOUS CONSEQUENCES. ONLY USE IMPACT SOCKETS DESIGNED FOR
USE WITH IMPACT TOOLS.
1. Select the impact socket you require, which must be in good condition and fit the tool exactly.
Push the socket onto the anvil as shown.
8
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]