Starter Size. Calculated Industries ElectriCalc Pro 5060, ElectriCalc Pro

Below you will find brief information for ElectriCalc Pro 5060. The ElectriCalc Pro 5060 makes quick work of complicated electrical calculations, helping you meet NEC requirements and complete your projects safely and efficiently. It features a user-friendly interface with easy-to-understand labels, and it’s pre-programmed with the 2002 National Electrical Code. It also includes the ability to update for future NEC revisions, giving you a tool designed to keep up with the times.

5060-UG-B-Composite 4/4/03 12:37 PM Page 53

Starter Size

What NEMA size starter is required for a 575 volt, 3Ø, 20 HP induction motor?

Steps Keystrokes Display

Reset calculator [On/C]

Enter volts 575 [Volts]

Enter hp

Solve for

575. VOLT

20 [HPmotor] 20. HP IND starter size [Set] [HPmotor] 2

STAR SIZE

Overload Protection Size

What overload protection device size is required for a 460 volt, 3-phase, 15 HP induction motor with a nameplate current rating of 19.2 amps and a 1.0 service factor? What is the required overload rating at 125% (for a 1.15 service factor)?

Steps Keystrokes Display

Reset Calculator [On/C]

Enter volts 460 [Volts]

460. VOLT

Enter horsepower 15 [HPmotor] 15. HP IND

Enter nameplate current 19.2 [Amps] 19.2 AMPS

Find overload size [O-Load] 22.08 ol AMPS

Display % used [O-Load]

Find 125% load 125 [O-Load]

115. %FLC

24.

Display % used [O-Load] ol AMPS

125 %FLC

User’s Guide — 51

Key Features

NEC-Updateable
Solves for volts, amps, VA, watts, kVA, kW, PF%, EFF%, and DC resistance
Determines copper or aluminum wire sizes
Calculates parallel and derated wire sizes
Calculates voltage drop wire sizes, % and actual voltage drops
Finds grounding conductors sizes
Calculates motor full-load amps
Calculates overload protection sizes
Calculates NEMA starter sizes
Calculates conduit sizes

Frequently Answers and Questions

How do I install the NEC update chip?

1) Purchase the NEC Update from CI 2) Once you receive the NEC Update chip, you need to install it in your ElectriCalc Pro: a) Turn calculator off. b) Remove the battery. c) Using a screwdriver, pop out the square tab located in the middle section on the back of your calculator. d) Replace it with the new Update tab by inserting it into the slot. e) Replace the battery door. f) Turn calculator on. Your calculator is now updated and ready to use.

How do I set the ambient temperature?

Press [Set] [2] and then enter the desired temperature using the number keys. The units can be displayed in Celsius (°C) or Fahrenheit (°F) by using the preference function ([Set][÷]).

How do I calculate the voltage drop?

Enter the phase, volts, amps, wire material, voltage drop wire size and length of run. The calculator determines resistance and then the voltage reduction. Voltage drop can be displayed as volts dropped, or as a percent reduction of potential load.