2002 NEC References. Calculated Industries ElectriCalc Pro 5060, ElectriCalc Pro

Below you will find brief information for ElectriCalc Pro 5060. The ElectriCalc Pro 5060 makes quick work of complicated electrical calculations, helping you meet NEC requirements and complete your projects safely and efficiently. It features a user-friendly interface with easy-to-understand labels, and it’s pre-programmed with the 2002 National Electrical Code. It also includes the ability to update for future NEC revisions, giving you a tool designed to keep up with the times.

5060-UG-B-Composite 4/4/03 12:37 PM Page 60

2002 NEC References

Table 250-66

Table 250-122

Table 310-15(b)(2)(a)

Table 310-16

Table 310-17

Chapter 9, Table 1, 4, 5 and 8

Section 430-32

Table 430-148

Table 430-150

Table 430-152

Appendix C

Updating Future Code

Revisions

This model is updateable for future

NEC Editions. For information on 2005 and 2008 Codes, contact the dealer where this calculator was purchased or you may contact Calculated Industries,

Inc. in the fall of the year prior.

58 — ElectriCalc Pro

Key Features

NEC-Updateable
Solves for volts, amps, VA, watts, kVA, kW, PF%, EFF%, and DC resistance
Determines copper or aluminum wire sizes
Calculates parallel and derated wire sizes
Calculates voltage drop wire sizes, % and actual voltage drops
Finds grounding conductors sizes
Calculates motor full-load amps
Calculates overload protection sizes
Calculates NEMA starter sizes
Calculates conduit sizes

Frequently Answers and Questions

How do I install the NEC update chip?

1) Purchase the NEC Update from CI 2) Once you receive the NEC Update chip, you need to install it in your ElectriCalc Pro: a) Turn calculator off. b) Remove the battery. c) Using a screwdriver, pop out the square tab located in the middle section on the back of your calculator. d) Replace it with the new Update tab by inserting it into the slot. e) Replace the battery door. f) Turn calculator on. Your calculator is now updated and ready to use.

How do I set the ambient temperature?

Press [Set] [2] and then enter the desired temperature using the number keys. The units can be displayed in Celsius (°C) or Fahrenheit (°F) by using the preference function ([Set][÷]).

How do I calculate the voltage drop?

Enter the phase, volts, amps, wire material, voltage drop wire size and length of run. The calculator determines resistance and then the voltage reduction. Voltage drop can be displayed as volts dropped, or as a percent reduction of potential load.

Related manuals

Download PDF

2002 NEC References. Calculated Industries ElectriCalc Pro 5060, ElectriCalc Pro 68 Pages

2002 NEC References. Calculated Industries ElectriCalc Pro 5060, ElectriCalc Pro

2002 NEC References

Updating Future Code