STORAGE. Ariens String Trimmer, Precision Edge 986101

Oil Change

NOTE: Follow instructions provided in the engine owner’s manual.

1. Stop engine, wait for all moving parts to stop and hot parts to cool. Make sure the engine shut off switch is in the off position.

2. Place an appropriate pan under the oil drain opening, and remove oil drain plug from engine.

3. After all oil has drained, replace the drain plug.

4. Fill engine with appropriate engine oil for your conditions. See Engine Manual for types of oil and operating ranges. Do not overfill.

Short Term Storage

IMPORTANT: NEVER clean unit with highpressure water or store unit outdoors.

Remove all dirt, grease, leaves, etc. Store in a clean dry area.

Inspect unit for signs of wear or damage.

Ensure all fasteners are properly tightened.

Long Term Storage

Follow all instructions under Short Term

Storage.

Store in a clean dry area.

Drain fuel from fuel tank.

Refer to Engine Manual for the proper engine storage procedures.

Touch up all scratched or chipped paint surfaces.

STORAGE

Fuel System

Gasoline left in the fuel system for extended periods without a stabilizer will deteriorate, resulting in gum deposits in the system.

These deposits can damage the carburetor and the fuel hoses, filter and tank. Prevent deposits from forming in the fuel system during storage by adding a quality fuel stabilizer to the fuel. Follow the recommended mix ratio found on the fuel stabilizer container.

To treat the fuel system for storage:

1. Add fuel stabilizer according to manufacturers’s instructions.

2. Run engine for at least 10 minutes after adding stabilizer to allow it to reach the carburetor.

NEVER store the engine with fuel in the fuel tank inside of a building with potential sources of ignition.

GB - 15