TROUBLESHOOTING. Ariens String Trimmer, Precision Edge 986101

Add to My manuals
20 Pages

Below you will find brief information for edger Precision Edge 986101. The Precision Edge 986101 is a powerful and versatile edger that can be used to create clean, sharp edges around your lawn, flower beds, and walkways. It features a 9-inch blade that can be adjusted to cut at different depths and angles. The edger also has a safety interlock system that helps to prevent accidental starts and injuries.

advertisement

TROUBLESHOOTING. Ariens String Trimmer, Precision Edge 986101 | Manualzz

TROUBLESHOOTING

PROBLEM PROBABLE CAUSE

Engine

Won’t Start

1. Engine start switch turned off.

2. Fuel tank empty.

3. Blade engaged.

Blade Won’t

Rotate

Wheels

Squeak

Front Wheel

Does Not

Slide

1. Loose or damaged belt.

2. Seized bearings.

3. Sliding shaft seized.

1. Bushings dry.

1. Front wheel bushings dry.

CORRECTION

1. Turn switch on. See Starting the Engine on page 12.

2. Fill engine with appropriate fuel. See engine owner’s manual for fuel type and capacity.

3. The cutting depth adjuster is out of the

neutral position. See Cutting Depth

Adjuster on page 9.

1. Replace belt.

2. Replace blade bearings.

3. Lubricate the sliding pivot shaft.

1. Lubricate the wheel bushings with a light oil.

1. Lubricate the wheel bushings with a light oil.

SERVICE PARTS

See your authorized Ariens dealer for

Genuine OEM service parts.

Part No.

Qty

03789800 1 Blade

07200507 1 Belt

Description

20020001 1 Spark Plug

20020002 1 Air Filter

00592900 1 Gas Stabilizer (4 oz.)

07100739 1 Front/Rear Wheel

GB - 16

advertisement

Key Features

  • 9-inch blade
  • adjustable depth and angle
  • safety interlock system
  • easy to use controls
  • durable construction

Related manuals

Frequently Answers and Questions

How do I adjust the cutting depth of the edger?
You can adjust the cutting depth of the edger by using the cutting depth adjuster lever. Pull the lever slightly to disengage the lock pin from the bracket and then pull the lever back to raise the cutting head and cut a shallower groove. Push the lever forward to lower the cutting head and cut more deeply.
How do I adjust the cutting angle of the edger?
You can adjust the cutting angle of the edger by using the cutting angle adjuster lever. Push the lever forward to unlock the head and then rotate it left or right to set the desired edging angle. The head pivots from about 70 degrees to 180 degrees.
How do I start the edger?
To start the edger, make sure the cutting head is disengaged, turn on the engine shut off switch, open the fuel shut off valve, set the choke to the closed position and the throttle to the fast position. Slowly pull the recoil starter until engine compression makes pulling difficult. Let the starter rewind a little, and then pull smoothly and quickly to start the engine. Repeat as needed. Close the choke when the engine starts and set the throttle to full fast before operating the unit.