Setting Jumpers. Toshiba 1202kit

Add to My manuals

advertisement

Setting Jumpers. Toshiba 1202kit | Manualzz

The following steps must be performed to properly install your DVD-RAM.

● Set drive’s jumpers

● Connect audio cable

● Attach IDE BUS cable

● Connect power cable

● Mount DVD-RAM

● Install CyberLink PowerDVD ™ software (used for viewing DVD movies)

● Install VOB InstantWritesoftware (used for recording CDs)

SETTING JUMPERS

The mode select jumpers are six (6) straight angle pins located on the rear of the

DVD-RAM. By placing a jumper on the pins, you can select the following functions:

CS: – Drive is configured using host interface signal CSEL

SL: – Configures drive as Slave

MA: – Configures drive as Master (default mode)

C

S

S

L

M

A

2

Mode Select Jumpers

In most installations, jumper should remain in MA (Master) position (factory default). It is recommended that you install your DVD-RAM only on the secondary IDE BUS. If you are installing on primary IDE BUS, your hard drive would then be the Master, and you should set your DVD-RAM to the Slave position (SL).

PLACING DVD-RAM INSIDE YOUR COMPUTER

Now that you have set your drive’s jumpers, you are ready to install your

DVD-RAM inside your computer.

IMPORTANT: Disconnect power from your computer system before beginning installation.

advertisement

Related manuals

advertisement