DVD-RAM Front Panel. Toshiba 1202kit

Add to My manuals

advertisement

DVD-RAM Front Panel. Toshiba 1202kit | Manualzz

DVD-RAM FRONT PANEL

The photo below illustrates the following features of the SD-W2002 DVD-RAM’s front panel:

Emergency Eject Hole: The emergency eject hole is to be used only when the DVD tray will not open when the Load/Unload button is pressed. Insert solid bar (i.e.

paper clip) into hole, applying gentle presure, until tray opens. Do not use Emergency Eject Procedure while the drive is in operation.

Loading Tray: Load disc using tray or recording cartridge

Load/Unload Button: Used to open the disc tray so you can install or remove a disc or recording cartridge.

Busy Indiactor: Provides status of drive.

DVD-RAM BACK PA N EL

The photo below illustrates the following features of the SD-W2002 DVD-RAMs back panel:

Digital Audio Out Connector: Outputs Digital Audio on the DVD-RAM.

Analog Audio Out Connector: Outputs Analog Audio on the DVD-RAM.

ATAPI Connector: Connects DVD-RAM to computer.

Power Connector: Connects DVD-RAM to power source.

Mode Select Jumper: Selects if drive is to be Master, Slave or Cable Select.

6

advertisement

Related manuals

advertisement