Handset Settings
Ringer Volume
• From the idle ( OFF ) mode, press SEL then or key to RINGER VOLUME .
• Press SEL again. The current ringer volume will be shown:
• Press or keys or enter digit 0-6 to the desired ringer volume. The current ring tone is played and the volume bar is increased/decreased each time the setting is adjusted. At the lowest setting, display will show:
NOTE : The Handset will not ring when a call comes in if Ringer Volume is set to the lowest setting.
• Press SEL to confirm the setting.
Ringer Tone
• From the idle ( OFF ) mode, press SEL then or key to RINGER TONE .
• Press SEL then you are prompted to choose
INTERCOM CALL or OUTSIDE CALL . Press
or keys to select the desired option.
• Press SEL again. You can then use or keys or enter digit 0-9 to sample the ring tone.
The screen, for example, will show:
• Press SEL to confirm your setting.
Key Tone (preset to ON)
• From the idle ( OFF ) mode, press SEL then or key to KEY TONE .
• Press SEL again. The current setting will be shown. Press or keys to scroll to ON or
OFF . When set to ON , the Handset will emit a beep whenever a key is pressed.
• When the desired option is shown, press SEL
21
Handset Settings to confirm your selection.
Handset Name (preset as ‘VTECH’)
• It is possible to give each Handset its own unique name. The name is shown in the first line when the Handset is idle. The name can be a maximum of 16 characters in length.
• From the idle ( OFF ) mode, press SEL then or key to HANDSET NAME.
• Press SEL again. The display will show the current setting, for example:
• Press DELETE to backspace then ‘spell’ the desired name.
NOTE : The characters are entered in the same way as for the phonebook, see the table on page
15.
• Press SEL to confirm the setting.
Language (preset to English)
• From the idle ( OFF ) mode, press SEL then
or key to LANGUAGE.
• Press SEL to select this option. Press or keys to scroll from English to French or Spanish.
• Press SEL to confirm the setting.
Dial Type (preset to Tone)
• From the idle ( OFF ) mode, press SEL then or key to DIAL TYPE .
• Press SEL then use or key to scroll to
TONE or PULSE .
• Press SEL to confirm your setting.
NOTE : When the phone is set for pulse dial mode, it is possible to switch to temporary tone mode during an ongoing call by pressing *TONE .
Once pressed, tone will be used for rest of the call. After you hang up, the phone will return to
22
