advertisement
SiriusXM
An example of the SiriusXM input source screen is shown in Figure 3 below.
Figure 3 – Example SiriusXM input source screen
TUnInG METHODS
You can use three methods to tune the 700 Series: manual, automatic and preset.
Encoder Menu key Play /
Pause
Rewind Fast
Forward
To tune to a required frequency, channel or preset:
Press the Play / Pause key to step through the available tuning methods for each band:
Note: Preset function only available if 2 or more presets are saved
16
17
Tuning
Method
Manual
Manual
Category
Auto
Scan
Preset
Applies to…
When tuning with this method…
All bands • Press the Forward or Backward key to step through the range of frequencies or channels one at a time.
• Press and hold down the key for rapid scanning of frequencies or channels.
SiriusXM • Press the Forward or Backward key to step through all channels one at a time.
SiriusXM • Press the Play / Pause, Forward or Backward key to step through the channels in the selected category.
• Only available when a category is selected in the
Category menu item. For further details see
“Category” on page 51.
AM/FM • Press the Forward or Backward key to start searching for available stations.
• Press the Play / Pause, Forward or Backward key to stop the search.
VHF • Scans through preset channels, pausing on a channel while it is transmitting.
• Only available if there are two or more presets saved.
• If there is any background noise, the scan will stop.
For further details see “Minimizing background noise” on page 19.
• Press the Play / Pause, Forward or Backward key to turn scan mode off. For further details see “Turning scan mode on” on page 19.
NOTE: The Scan function is activated from the settings menu, see ‘Setting up VHF’
All bands • Press the Forward or Backward key to step through available presets.
• Only available if there are two or more presets saved.
• To tune to a specific preset: a. Press the Menu key, and then press the
Encoder to select Presets. b. Turn the Encoder to highlight the required preset.
c. Press the Encoder to tune to the highlighted preset.
For further details, see “Adding and Removing Presets” on page 18.
advertisement
