Step 3: Installing the Cables. HP 8500 N, 8500 DN, 8500, Color LaserJet 8500 Printer series

Add to my manuals
56 Pages

advertisement

Step 3: Installing the Cables. HP 8500 N, 8500 DN, 8500, Color LaserJet 8500 Printer series | Manualzz

EN

Step 3: Installing the Cables

To connect the power cord to a printer with a stand

N o t e

Make sure that the printer is off (power button out) before connecting the power cord.

1 Roll the printer to its permanent location, where all four wheels rest on a level floor surface, and stabilize it by pushing the locking tabs on the printer stand’s wheels to the locked position.

W A R N I N G !

An unstable printer can tip over and cause injury; make sure that the printer is secured properly.

2

3

Plug the female end of the power cord into the connector on the back left corner of the printer.

Plug the male end of the power cord into a surge protector or other grounded power source.

Step 3: Installing the Cables 9

10 Step 3: Installing the Cables

To connect the interface cable and power cords for a printer with an optional tray 4

N o t e

Make sure that the printer is off (power button out) before attaching the interface cable and connecting the power cords.

1 Locate the interface cable (A), the power pack (B), and the straight power cord (C).

N o t e

The interface cable (A) might already be attached to the printer and tray 4. If it is, proceed to step 4 below; otherwise, continue with step 2.

2

3

4

Attach the end of the interface cable that is marked with one dot to the printer above the parallel connector.

Attach the other end of the interface cable (marked with two dots) to the connector on tray 4 that is marked with two dots.

Attach the power pack to the back of the printer by inserting the clip into the space between the printer and tray

4.

EN

5

6

7

8

Push the two cables extending from the power pack into the space between the printer and tray 4 along the back of the printer.

Plug the shorter of the two cables into the connector on the back left corner of the printer.

Plug the longer of the two cables into the connector on the back left corner of tray 4.

Plug the female end of the power cord into the male connector on the bottom of the power pack.

EN

Step 3: Installing the Cables 11

12 Step 3: Installing the Cables

9

10

Roll the printer to its permanent location, where all four wheels rest on a level floor surface, and stabilize it by pushing the locking tabs on the tray’s wheels to the locked position.

Rotate the feet of the five stabilizing legs and the anti-tip foot (on the left side of the tray) until they are snug against the floor.

W A R N I N G !

An unstable printer can tip over and cause injury; make sure that the printer is secured properly.

11 Plug the male end of the power cord into a surge protector or other grounded power source.

N o t e

If an optional multi-bin mailbox was ordered, see the installation guide included with the mailbox for installation instructions.

EN

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertisement