Using the Lithium Ion Battery Pack. Samsung D303(i), D307(i), D305(i), D303D(i), VP-D301(i)

Add to My manuals
113 Pages

advertisement

Using the Lithium Ion Battery Pack. Samsung D303(i), D307(i), D305(i), D303D(i), VP-D301(i) | Manualzz

00752F VP-D303(i)-UK (01~27) 5/28/04 9:54 AM Page 24

ENGLISH

Preparation

Using the Lithium Ion Battery Pack

The amount of continuous recording time available depends on.

The type and capacity of the battery pack you are using.

- How often the Zoom function is used.

It is recommended that you have several batteries available.

Charging the Lithium Ion Battery Pack

1. Attach the battery pack to the camcorder.

2. Connect the AC Power adapter to an AC cord and connect the AC cord to a wall socket.

3. Connect the DC cable to the DC jack socket on the camcorder.

4. Turn the Camera power switch to off, and the charging indicator will start to flash, showing that the battery is charging.

Blinking time

Once per second

Twice per second

Three times per second

Blinking stops and stays on

On for a second and off for a second

Charging rate

Less than 50%

50% ~ 75%

75% ~ 90%

90 ~ 100%

Error - Reset the battery pack and the DC cable

Power Switch

5

5. When the battery is fully charged, disconnect the battery pack and the AC Power adapter from the camcorder.

■ Even with the power switched off, the battery pack will still discharge if it is left connected to the camcorder.

Notes

The battery pack may be charged a little at the time of purchase.

To prevent reduction in the life and capacity of the battery pack, always remove it from the camcorder after it is fully charged.

00752F VP-D303(i)-UK (01~27) 5/28/04 9:54 AM Page 25

ENGLISH

Preparation

Using the Lithium Ion Battery Pack

Table of continuous recording time based on model and battery type.

✤ If you close the LCD screen, it switches off and the viewfinder switches on automatically.

✤ The continuous recording times given in the table above are approximations.

Actual recording time depends on usage.

Time

Battery

Charging time

Continuous recording time

LCD ON VIEWFINDER ON

SB-LS110

Approx.

2hr

Approx.

1hr 30min

Approx.

2hr

SB-LS220

Approx.

3hr 30min

Approx.

3hr 10min

Approx.

4hr 10min

Notes

The battery pack should be recharged in an environment of between 32°F (0°C) and 104°F (40°C).

The battery pack should never be charged in a room temperature that is below 32°F (0°C).

The life and capacity of the battery pack will be reduced if it is used in temperatures below 32°F (0°C) or left in temperatures above 104°F (40°C) for a long period, even when it is fully recharged.

Do not put the battery pack near any heat source (fire or flames, for example).

Do not disassemble, process, pressure, or heat the Battery Pack.

Do not allow the + and - terminals of the battery pack to be short-circuited.

It may cause leakage, heat generation, induce fire and overheating.

00752F VP-D303(i)-UK (01~27) 5/28/04 9:54 AM Page 26

ENGLISH

Preparation

Battery level display

• The battery level display indicates the amount of power remaining in the battery pack.

a. Fully charged b. 20~40% used c. 40~80% used d. 80~95% used e. Completely used (flickers)

(The camcorder will turn off soon, change the battery as soon as possible)

✤ Please refer to the table on page 25 for approximate continuous recording time.

✤ The recording time is affected by environmental temperature and conditions.

The recording time becomes very short in a cold environment. The continuous recording time in the operating instructions are measured using a fully charged battery pack at

77°F(25°C). As the environmental temperature and conditions may differ when you actually use the camcorder, the remaining battery time may not be the same as the approximate continuous recording times given in these instructions.

Tips for Battery Identification

A charge mark is provided on the battery pack to help you remember whether it has been charged or not.

Two colours are provided (red and grey)-you may choose which one indicates charged and which indicates discharged.

Note

The charge mark setting does not affect the battery's charge status.

a b c d e

advertisement

Related manuals

advertisement

Table of contents