AA68-03583A-01Eng_SEA 6/14/05 2:14 PM Page 14
I
N S TA L L AT I O N
Connecting a VCR
These instructions assume that you have already connected your TV to an antenna or a cable
TV system (according to the instructions on pages 10-13). Skip step 1 if you have not yet connected to an antenna or a cable system.
1
Unplug the cable or antenna from the back of the TV.
2
Connect the cable or antenna to the
ANTENNA IN terminal on the back of the VCR.
Incoming
Cable or
Antenna
VCR Rear Panel
3
Connect a coaxial cable between the ANTENNA
OUT terminal on the
VCR and the antenna terminal on the TV.
VCR Rear Panel
TV Rear Panel
Coaxial Cable
A coaxial cable is usually included with a VCR. (If not, check your local electronics store).
4
Connect a set of audio cables between the
AUDIO OUT jacks on the
VCR and the AUDIO jacks on the TV.
VCR Rear Panel
Audio Cable
TV Rear Panel
5
Connect a video cable between the VIDEO OUT jack on the VCR and the
VIDEO jack on the TV.
VCR Rear Panel
Video Cable
TV Rear Panel
Follow the instructions in “Viewing an External Signal Source” to view your VCR tape.
English - 14
AA68-03583A-01Eng_SEA 6/14/05 2:14 PM Page 15
I
N S TA L L AT I O N
Connecting an S-VHS VCR
Your Samsung TV can be connected to an S-Video signal from an S-VHS VCR. (This connection delivers a better picture as compared to a standard VHS VCR.)
1
To begin, follow steps
1–3 in the previous section to connect the antenna or cable to your
VCR and your TV.
VCR Rear Panel
Coaxial Cable
TV Rear Panel
2
Connect a set of audio cables between the
AUDIO OUT jacks on the
VCR and the 2 AUDIO
INPUT jacks on the TV.
VCR Rear Panel
TV Rear Panel
Audio Cable
Make sure the jacks you are using are underneath the number “2.”
3
Connect an S-video cable between the
S-VIDEO OUT jack on the VCR and the
S-VIDEO INPUT jack on the TV.
VCR Rear Panel
Video Cable
TV Rear Panel
An S-video cable is usually included with an S-VHS VCR. (If not, check your local electronics store.)
English - 15
AA68-03583A-01Eng_SEA 6/14/05 2:14 PM Page 16
I
N S TA L L AT I O N
Connecting a Second VCR to Record from the TV
Your TV can send out signals of its picture and sound to be recorded by a second VCR.
To do this, connect your second VCR as follows:
1
Connect a set of audio cables between the
AUDIO OUT jacks on the
TV and the AUDIO IN jacks on the VCR.
TV Rear Panel
Audio Cable
VCR Input Panel
(The VCR input jacks might be either on the front or on back of the VCR.)
2
Connect a video cable between the VIDEO OUT jack on the TV and the
VIDEO IN jack on the
VCR.
TV Rear Panel
Video Cable
VCR Input Panel
Refer to your VCR’s instructions for more information about how to record using this kind of connection.
English - 16