advertisement
How to Install Batteries
Using the Remote Control Unit
1.
Slide the cover in the direction indicated by the arrow and remove it.
2.
Install two AAA alkaline batteries. Make sure the batteries point in the direction marked in the battery compartment.
3.
Use a thin object such as the tip of a pen to press the ACL button.
oi202000
ACL button
NOTE
•
The batteries last about six months, depending on how much you use the remote control unit. Replace the batteries when the remote control unit's display fails to indicate, or when the remote control cannot be used to change the air conditioner’s settings.
•
Use two fresh leak-proof type-AAA alkaline batteries.
• In replacing batteries, follow the instructions as mentioned in the sub-section “How to Install Batteries”.
• If you do not use the remote control unit more than 1 month, take out the batteries.
How to Use the Remote
Control Unit
When using the remote control unit, always point the unit’s transmitter head directly at the air conditioner's receiver.
Air conditioner
(Indoor unit)
Receiver
(Transmitter head)
Remote control unit
Remote Control Unit
Installation Position
The remote control unit may be operated either from a non-fixed position or from a wall-mounted position. To ensure that the air conditioner operates correctly, DO NOT install the remote control unit in the following places:
DO NOT • In direct sunlight
• Behind a curtain or other places where it is covered
• More than 26 feet (8 m) away from the air conditioner
• In the path of the air conditioner’s airstream
• Where it may become extremely hot or cold
• Where it may be subject to electrical or magnetic noise
• Where there is an obstacle between the remote control unit and air conditioner (since a check signal is sent from the remote control unit every 5 minutes)
10
OI-351-10EG
Mounting the Remote
Control Unit
Using the Remote Control Unit (continued)
Truss-head tapping screws
5/32 x 5/8 “ (4 x 16 mm)
(supplied)
Press
Remote control unit holder
Hook
When attaching to wall 1) Confirm the indoor unit beeps when the ON/OFF button is pressed at the wall location where the remote control unit is to be attached, then attach the holder to the wall.
2) When taking out the remote control unit, pull it from the holder.
When using the remote • Point the transmitter on the remote control unit at the sensor on the control unit indoor unit when operating the remote control unit and the air conditioner.
• Do not place objects which may block the transmitted signals between the receiver and the remote control unit.
Truss-head tapping screws
5/32 x 5/8 “ (4 x 16 mm)
(supplied)
Holder
Remote control unit holder
Securing the remote 1) Attach the holder to the wall with one screw in the upper hole only.
control unit to prevent theft
2) Remove the cover from the remote control unit, and then remove the batteries. Next, place the remote control unit in the holder.
3) Secure both the remote control unit and the holder to the wall with another screw through the lower hole.
4) Put the batteries back in the remote control unit, and then replace the cover.
OI-351-11EG
11
advertisement