INSTALLATION REQUIREMENTS. KitchenAid KEWS175BSS, KEWS175BPA


Add to My manuals
12 Pages

advertisement

INSTALLATION REQUIREMENTS. KitchenAid KEWS175BSS, KEWS175BPA | Manualzz

INSTALLATION REQUIREMENTS

Product Dimensions Tools and Parts

Gather the required tools and parts before starting installation.

Read and follow the instructions provided with any tools listed here.

Tools needed

■ Phillips screwdriver

Drill

1 ³⁄₈" (3.5 cm) hole saw

Parts supplied

■ 4 - #8-18 x ⁵⁄₈" screws

■ Lens (for panel ready models)

Check local codes. Check existing electrical supply. See

“Electrical Requirements.”

It is recommended that all electrical connections be made by a licensed, qualified electrical installer.

Location Requirements

IMPORTANT: Observe all governing codes and ordinances.

■ Cutout dimensions that are shown must be used. Given dimensions provide minimum clearance with warming drawer.

■ Recessed installation area must provide complete enclosure around the recessed portion of the warming drawer.

Grounded electrical supply is required. See “Electrical

Requirements” section.

Electrical supply outlet should be located in the rear wall on the upper right-hand side of the cutout or in an adjacent cabinet. The outlet must be recessed. If the electrical outlet is located in an adjacent cabinet, a 1 ³⁄₈" (3.5 cm) minimum diameter hole should have been drilled in the back of the cutout or support surface to pass the power supply cord through to the outlet.

Warming drawer support surface must be solid, level and flush with bottom of cabinet cutout.

Warming drawers with oiled bronze, black glass, and white glass panels are approved for indoor use only.

For best performance results, make sure the warming drawer is leveled before completing installation. There is no way to level the warming drawer after it has been installed. If the installation is not level, the door may slide open or not seal tightly, allowing heat to escape.

NOTE: If installing the warming drawer below another product, refer to that product’s literature for any installation requirements.

A

WARMING

DRAWER

SIZE

24"

(61 cm)

27"

(68.6 cm)

30"

(76.2 cm)

OVERALL

WIDTH (A)

23

³⁄₄"

(60.3 cm)

26 ³⁄₄"

(67.9 cm)

29

³⁄₄"

(75.6 cm)

Cabinet Dimensions

Cabinet Side View

Warming drawer front

22

³⁄₄

"

(57.8 cm) recessed oven depth

24"

(61 cm) min. cutout depth

B

RECESSED

WIDTH (B)

22

¹⁄₄"

(56.5 cm)

25 ¹⁄₄"

(64.1 cm)

28

¹⁄₄"

(71.8 cm)

C

RECESSED

HEIGHT (C)

9"

(22.9 cm)

9"

(22.9 cm)

9"

(22.9 cm)

Support surface must be solid, level, flush with bottom of cabinet cutout.

3

advertisement

Related manuals