INSTRUCTIONS FOR WARMING DRAWERS. KitchenAid KEWS175BSS, KEWS175BPA


Add to My manuals
12 Pages

advertisement

INSTRUCTIONS FOR WARMING DRAWERS. KitchenAid KEWS175BSS, KEWS175BPA | Manualzz

6

CUSTOM DRAWER FRONT INSTALLATION INSTRUCTIONS

FOR WARMING DRAWERS

Tools and Parts

Gather the required tools and parts before starting installation.

Read and follow the instructions provided with any tools listed here.

Tools Needed

■ Phillips screwdriver

■ Drill and appropriate bits

Parts Supplied

■ 6 - #8-18 x ¹⁄₂" screws

■ Indicator light lens

3. It is recommended that if a wood or porous custom drawer front is installed, a high quality spray polyurethane finish be applied to the inner wood surface.

4. For the lens, drill a ⁵⁄₁₆" (7.9 mm) diameter hole through the appearance side of the custom drawer front. This hole will allow the indicator “ON” light to be visible through the custom drawer front. To secure the lens, use an adhesive specified for plastic to wood application.

5. Install custom handle (not supplied) through custom drawer front.

6. The custom drawer front is fastened to the stainless steel drawer by driving 6 screws through clearance holes in the drawer front into the wooden or other custom made panel.

Parts Needed

■ Custom drawer front

Custom handle (optional)

Adhesive recommended for plastic to wood

A

D

C

Install Custom Drawer Front Panel

The warming drawer has an interface that will allow a modest range of panel sizes. The actual panel size should be selected by the customer and the contractor to suit the desired effect. It is recommended that a qualified carpenter make and install the custom drawer front and handle(s) to match surrounding cabinetry.

1. Install warming drawer unit as instructed by the installation instructions provided with the warming drawer.

2. Create the custom drawer front. Below are the minimum and maximum dimensions for the custom drawer front. The size of the custom drawer front for the warming drawer will vary according to the specific installation. The depth of the panel will vary in order to have the custom warming drawer flush with the surrounding cabinets.

A

B

E

A. Optional handle

B. Custom door panel

C. Warming drawer front

D. 6 - #8-18 x ¾" screws

E. Lens

D

⁵⁄₁₆ " (7.9 mm) dia. hole for indicator light lens (provided in this kit). Locate lens directly in front of indicator light.

B

Model

24" (61 cm)

Warming Drawer

27" (68.6 cm)

Warming Drawer

30" (76.2 cm)

Warming Drawer

A - MAX B - MAX A - MIN B - MIN

23 ³⁄₄"

(60.3 cm)

10 ⁵⁄₁₆"

(26.2 cm)

23"

(58.4 cm)

9 ¹⁄₁₆"

(23.0 cm)

26

³⁄₄"

(67.9 cm)

29 ³⁄₄"

(75.6 cm)

10

10

⁵⁄₁₆"

(26.2 cm)

⁵⁄₁₆"

(26.2 cm)

26"

(66.1cm)

29"

(73.7cm)

9

¹⁄₁₆"

(23.0 cm)

9 ¹⁄₁₆"

(23.0 cm)

advertisement

Related manuals