maintain tools and fi lter. Samsung SC4740

maintain tools and fi lter

USING ACCESSORY

Pipe (Option)

• Adjust the length of the telescopic pipe by sliding the length control button located in the center of the telescopic pipe back and forth.

• To check for blockages, separate the telescopic pipe and adjust to shorten. This allows for easier removal of waste clogging the tube.

Accessory

• Dusting brush for furniture. shelves, books, etc.

• Crevice tool for radiators, crevices, corners, between cushions.

08_ maintain

MAINTAIN FLOOR TOOLS

2-Step Brush (Option)

• Adjust the inlet lever according to the fl oor surface.

• Remove waste matter completely if the inlet is blocked.

Pet Brush (Option)

For improved pick-up of pet hair and fi bre on carpets.

Frequent vacuuming of hair or pet fur may cause a falling-off of the rotation due to matters tangled around the drum. In this case, clean the drum with care.

Blanket brush (Option)

Clogs on turbine keep brush from turning, thus need to be unclogged as follows. For picking up pet hair and fi bre on upholstery and bed linen.

Remove waste matter completely when inlet is blocked.

Turn the lock button to ‘UNLOCK’, and remove waste matter.

To reassemble, align the cover to the front of the main body and close. After closing the cover, ensure that the lock button is turned to the ‘LOCK’ position.

WARNING

Use for bedclothes only. Be cautious not to damage brush during unclogging.

maintain _09

maintain tools and fi lter

Mini turbo brush (Optional)

- TO REPLACE BRUSHROLL

1. If a clog is present or debris is visible, unscrew the two screws on the back of the Mini turbo brush to remove the faceplate and clear any obstructions.

2. Inspect condition of brushroll.

Replace brushroll if brushes are worn down.

To remove brushroll, pull up and out of end slots in nozzle housing.

Insert ends of brushroll into same slots to replace.

Inspect belt to ensure that it is in good condition.

If belt is broken or cracked, replace belt according to To Replace Belt instructions.

3. Using at MAX.

Press the MAX button to operate the vacuum at maximum intake.

- TO REPLACE BELT

1. Remove bottom plate.

See fi gure in To Replace Brushroll instructions.

2. Loop one end of new belt around shaft of pulley.

3. Loop other end of belt around designated area for it on brushroll. Insert brushroll into slots in nozzle housing.

See fi gure in To Replace Brushroll instructions.

4. Fit Mini turbo brush back together as described in

To Replace Brushroll instructions.

10_ maintain

EMPTYING THE DUST BIN

1. Once dust reaches the dust full mark, or sution

2. Take the dust bin out by pressing the button.

is noticeably reduced during cleaning, empty the dust bin.

3. Separate the dust bin cover.

4. Throw away dust into the bin.

5. Close the dust bin cover.

6. Before use, push the dust bin into the main body of the vacuum cleaner until you hear the “click” sound.

- Empty into a plastic bag

(recommended for asthma/ allergy sufferers)

You may rinse the dust bin with cold water.

maintain _11

maintain tools and fi lter

WHEN TO CLEAN THE DUST PACK

- If suction is noticeably reduced during cleaning, please check the dust pack as indicated below.

Turn the vacuum power to ‘MAX’.

If suction is noticeably reduced with the inlet fl oating 10cm above fl at fl oor, clean it.

When suction is noticeably reduced continuously, please cleaning the Dust Pack as shown in the following illustration.

12_ maintain

CLEANING THE DUST PACK

1. Remove the dust bin and dust pack as shown.

2. Remove the sponge and fi lter from the dust pack.

3. Wash the sponge and the fi lter of the dust pack with water.

4. Let the sponge and fi lter dry in the shade for more than 12 hours.

5. Put the sponge and fi lter into the dust pack.

6. Put the assembled dust pack into the main body.

Make sure the fi lter is completely dry before putting it back into the vacuum cleaner. Allow 12 hours for it to dry.

maintain _13

CHANGE THE BATTERY (OPTION)

1. When the vacuum cleaner dows not work, replace the batteries. If the problem persists, please contact our authorized dealer.

2. Use 2 batteries of size AA.

WARNING

1. Never disassemble or recharge the batteries.

2. Never heat up the batteries or throw them into fi re.

3. Do not reverse (+), (-) poles

4. Dispose of the batteries property.

Size maintain _15