Ethernet Installation. ELTEC BAB 40/60
Publicité
Publicité
BAB-40/60 2 Installation
2.1.5
Ethernet
Installation
2.1.6
SCSI
Installation
A standard Ethernet/Cheapernet MAU or a CONV-500 Cheapernet/
10BaseT MAU can be connected via AUI cable to the 15-pin AUI connector on the front panel of the BAB-40/60. The length of the AUI cable is limited to 50 m. For connections up to about 2 m, flat cable can also be used. In order to avoid HF radiation, this cable should be shielded.
A 8-bit SCSI bus can be connected to X103 of ADAP-200. If the
BAB-40/60 is located at either end of the SCSI bus, the termination must be enabled in the RMon setup menu, otherwise it must be disabled.
Hardware Manual 29
2 Installation
Figure 3: Installation Diagram
S902
S901
U903
X702
X701
X801
VGA
Keyboard
X1101
BAB-40/60
30 Hardware Manual
Télécharger
Publicité