Overview of Network Setup and Configuration. Xerox 7760, Phaser 7760DX, Phaser 7760DXF

Add to my manuals
158 Pages

advertisement

Overview of Network Setup and Configuration. Xerox 7760, Phaser 7760DX, Phaser 7760DXF | Manualzz

Overview of Network Setup and Configuration

Overview of Network Setup and Configuration

To set up and configure the network:

1.

Turn on the printer and the computer.

2.

Connect the printer to the network using the recommended hardware and cables.

3.

Print the Configuration page and keep if for referencing network settings.

4.

Configure the printer’s network address, which is required to identify the printer on the network.

Windows operating systems: Run the Installer on the Software and Documentation

CD-ROM to automatically set the printer’s IP address if the printer is connected to an established TCP/IP network. You can also manually set the printer’s IP address on the control panel.

Macintosh systems: Manually set the printer’s network address (for TCP/IP) on the control panel.

5.

Install the driver software on the computer from the Software and Documentation

CD-ROM. For information on driver installation, see the section in this chapter for the specific operating system you are using.

Note: If the Software and Documentation CD-ROM is not available, you can download the latest driver from www.xerox.com/office/drivers .

For more detailed networking information, see the Advanced Features Guide at www.xerox.com/office/7760support.

Phaser® 7760 Color Laser Printer

2-2

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertisement

Table of contents